Used Equipment Tillage Equipment For Sale In Brookshire

Balderson Blade with Quick Connect for Wheel Loader 988 In good condition was used with a 988F wheel loader.

Fits Caterpillar 140H, 143H, 160H, 163H, 104G

It has fresh tires. Can ship anywhere or pick you up at the airport. I can throw in piping that came with it. Ready to work, DOT inspected. 2007 Troxell 130 BBL Kill Trailer / Vacuum Trailer, 2 compartment 40/90 split,Carboline Plasite 4300 brand new...

1999 Galbreath Model: A5-OR-402 Roll Off Trailer, Tri-axle with big tires, 30,000lbs G.VW.R, 21,200lbs G.A.W.R., cable hoist roll off, 5th wheel. Works good, good rails. Solid frame, no rust or dents, etc.

6 x 14.00 x 24 Tires Only @ 50% Remaining.

Both Blade and bucket for 988B

Original Cat Multi Shank Ripper Came Of A 140H Has 3 Cat Ripper And 8 Cat Scarifier Shanks, In Excellent Conditoin . Complete With Mounting Rods.

Fresh paint all around, good tires. These trucks will haul grease, septic, water, sludge, mud, and HAZMAT material for your specialized jobs. Very, very powerful Wittig HYDRAULIC vacuum pump.

This truck has been serviced at the Peterbilt dealer as well. Ready to work, no check lights, no air leaks or oil leaks. PTO is activated outside of cab on drivers side, with clutch lever and pto lever so you dont have to hop in the truck to activate...

Mack 427HP engine, eaton fuller 13 speed, NVE vacuum pump with transfer gear pump too, tandem axle, air ride, 3,500 gallon vacuum tank, 3.90 ratio, 230"in wheelbase, 12,000lbs fronts and 40,000lbs rears.

I have several kill trucks available. Spring suspension, heavy spec, double frame. 2001 Mack RD688S Bobtail Kill Truck/ pressure truck/ pump truck with 60BBL Vacuum tank, with 260,000 miles, Gardner Denver Tee Triplex pump at 10,000psi, bowie centrifugal...

Truck sells ready to work, DOT inspected. Fresh engine oil change. Water heater boiler. 2008 International 7600 Vactor HXX Hydroexcavator with a big blower, Hibon 8702, 29"HG, 5600 cfm, Caterpillar C13, Eaton Fuller 10 speed, full open rear gate, full...

Good trailer, ready to work. 4 Beam style frame, with tail roller in the back. Air brakes, good tires, the trailer has 18 pair of D rings for tie down along the both sides, mechanical removable neck.

Clean and ready to work. It has inside cab control as well as controls in the outside. No cylinder leaks, no hydraulic leaks or any oil leaks for that matter. Truck has aluminum fenders in the rear, not bend or scratched.

A/C Condition: Excellent, A/C, State DOT, Headache Rack, Turbo Hendrickson Walking beam suspension, 20,000lbs fronts and 58,000lbs rears. Beautiful monster 2006 Mack Granite CV713 Gin Pole Winch Truck with 123,000 miles!!! Mack AMI 12.0L engine, 338"...

Brand new valves all around, fresh tires all around, fresh sandblast and paint all around. Caterpillar C-13, 36,000 miles, Engine hours are 5,102 hours. Blower hours are 3,002 hours.

Trucks sell DOT inspected. A/C Condition: Excellent, A/C, Differential Lock, State DOT, Turbo Can ship anywhere or pick you up at the airport. Ready to work, DOT inspected. 14,600lbs and 46,000lbs rears.

2 AVAILABLE: Will ship anywhere!!! 2006 Sterling Superproducts Supersucker Air Mover. All the control panel gauges are new, rpm gauge, air vacuum gauge, etc. The dash on interior is very good, no broken pieces on dash or cracks.

FINANCING AVAILABLE AT LOW RATES 6 Ramvac Hydrovacs available on Kenworth chasis. Sells ready to work, DOT inspected. Boom reach is 26". 2012 and 2013 Kenworths T800 Ramvac HX-12 Hydrovac with low miles from 20,000 to 80,000 miles.

I have 3 available. This truck has been fully refurbished and is ready to work. Eaton 10 speed transmission, PTO, good tires, tank meter. 2005 Sterling Vacuum Truck DOT CODE/HAZMAT/ 407/412.

MADE IN USA NEW / UNUSED SCARIFIER NEW UN TO FIT 140M, 12M, 160M . COMES EQUIPPED WITH 5 SHANKS IN STOCK READY FOR DELIVERY.

Good Tires All Around, Has A Blower

Sells DOT inspected. It has full rolling tailboard, hydraulic Tulsa 45,000lbs winch and a hydraulic NVE 367 Challenger vacuum pump, 14,000lbs fronts and 40,000lbs rears. Beautiful 2013 Kenworth T800 Winch Truck ready to get the job done.

Truck is ready to work, DOT inspected. Can haul frac tanks and you can haul vacuum tankers with the pump, or use the winch to assist with loads. 353,000 miles, Maxitorque 13 speed transmission, Tulsa 45,000lbs hydraulic winch and has 2016 Jurop PN84 vacuum...