Used Equipment Other Equipment For Sale In Campbellton

500 bu, corner auger, large 1000 pto, clean cart.

Markers, great blades and coulters, only showing 6197 acres on counter. 15' no-till or drill can be detached for use as a 3pt. Very sharp drill, Field ready Conventional drill , 22x8, press, double disc, Yetter hyd.

30', sliding tounge, unit was a demo, like new

Gravity wagons, several in stock, Starting @ $1,250.

5 bottom in furrow

6R36, dry drive, CM shafts, straight tin, We leased this head out in fall of 2017 to cut 300 acres with no problems. Can convert back to sprocket drive if needed Deck Plates: Manual, Field Ready, Snout Type: Metal, Telescoping Drive

Good 15' flex head, 3" cut, poly tines, dividers, (3) Available.

Has a couple of welds. 29'3", rock flex, rear hitch and hydraulics for crumbler, hydraulic fore/aft, walking tandems, 23" front and 24" rear blades. Field ready Front Disk Blade Size: 23, Rear Disk Blade Size: 24, Walking Tandems

All bought new at same time w/ consecutive serial numbers, slip tounges, all metal, no wood, great rubber, light kits. Good clean wagons with very little use. Or 8,500 for pair.

Will fit K or K2 machine. Wings taken off for transport Deck Plates: Manual, Outer Side Shield, Snout Type: Metal Clean hard-to find head.

Good clean 20' drill set up for soybeans, 20x15, planter units, V-press, hydraulic markers, spray bar, 3 pt.

21x7, double disc, 3" press, cylinder Disc Opener Type: Double, Drill Type: Pull, End Wheels, Field Ready, Number of Openers: 21

21x7, double disc, double run, good blades Disc Opener Type: Double, Drill Type: Pull, Field Ready, Number of Openers: 21

6RW, hyd fold, hyd pump,

500 gallon, 45' booms, 3 way nozzles, foamers, walking tandems, pto pump, manual lift, no controls Foam

18' flex, 3" cut, Stainless floor, Sprocket drive, Poly, Good auger and floor, Dividers taken off for transport

Off K2 combine. 2R30, very clean hard-to-find head. Wings off for transport Deck Plates: Manual, Outer Side Shield, Snout Type: Metal

Good 15' flex head, 3" cut, metal tines, (3) Available.

Cart not included Good auger and floor. Dividers taken off for transport. 20' flex, 3" cut, sprocket drive. Very sharp head for year.

4R36, high tin, dry drive, dual sprocket drive, stalk chompers, sprockets and chain are fair/good. Head only, no cart Deck Plates: Manual, Field Ready, Snout Type: Metal, Stalk Stompers: 2

Cab, Air, Heat, Radio, Forward Speed: 8, Front Tire % Remaining: 30, Front Tire Size: 28.1-26, Front Tire Type: Singles, Front Weights: yes, Fuel Type: Diesel, PTO: 1000, PTO Size: 1 3/8, Rear Tire % Remaining: 30, Rear Tire Size: 28.1-26, Rear Tire Type:...

4R36, Great chains, sprockets, rollers, knives, floor and tin. Has stalk chomper, Field ready

Head has been test run and sounds good. Straight head w/ good tin. Head only, no cart! Deck Plates: Manual, Telescoping Drive Dual jackshafts, Good rollers, chains, sprockets and knives.

Heads available Auto Reel Speed, Crop Type: Corn/Beans, Drive Tire % Remaining: 80, Drive Tire Size: 24.5-32, Fore/Aft Reel, Fuel Type: Diesel, Grain Loss Monitor, Grain Tank Size: 145, Rear Attachment: Straw Spreader, Separator Type: Rotor, Steering...

45' booms, 3 way nozzles, foamers, controls, pto pump, hydraulic lift, single axle, mix tank Foam

20' flex head w/ 3" cut, tear drop reel, hyd. Fore/aft, single drive, dividers, (3) Available.

3" cut, pipe reel, double drive, grain grabbers, dividers, good floor and auger, head only, no cart