It has an extendable dipperstick along with three spool loader hydraulics. This is a 2004, Four-Wheel Drive, Terex TX760B, Open Rops Bachoe. It has around 850 Hours on it. This machine is priced at $36,900.00 picked up in Rosenberg, TX.
This is a brand new Stationary Snap On air compressor for a auto repair shop. 60 gallons capacity, 5.0 hp, 140 max psi. It has never been installed. 60 gallon capacity. 5.0 hp, 140 max, psi.
Thick , reclaimed from a green puilding project . Excellent condition . This sheating will retard heat flow into building during summer and keep heat inside buiding during the winter .This is not your typical insulation .
I am in upstate New York Hydraulic tilt table for hoof trimming of cattle wanted. New or used hydraulic tilt table for hoof trimming of cows wanted for dairy farm in upstate New York.
The tracks are 30\" tracks and have 95% rubber left on them. This is a 340 H.P tractor. This tractor only has 5,150 hours on it. This unit is field ready and olny cost $75,000.
Comes with loader, and tractor hydraulic quick coupler, and pioneer fittings on tractor end of the hoses to plug into rear tractor remotes. Alo/global q-tach, and hydraulic quick coupler.
It has around 11,000 hrs on it. Tractor 192 PTO H.P Tractor, this tracor is ready to go to the field. This tractor is 192 PTO H.P. Tractor, 4wd, Cab with Air Condition. It has 3 sets of Hydraulic remotes, front weights, 1000 RPM PTO, and has a Quick Hitch...
Cylinder head for L3410 Kubota tractor part number 16467-03045cylinder head for L3410 Kubota tractor part number 16467-03045. Cylinder head for L3410 Kubota tractor.
BUILT IN 2010 AND USED AT EVENTS. DETROIT DIESEL DISPLAY,QUINCY AIR COMPRESSOR USED TO POWER AIR STARTER ON GM 8-V-71 318 HP MOTOR ALSO INCLUDES A GM 6-71 238 HP, 6-V-53 TA 250 HP AND A GM 3-53 75 HP MOTOR ALL BUILT ONTO A TRI AXLE TRAILER.
Needs some minor repais as well as new battery and new front tires. Available for viewing and shipping can be arranged. Engine turns over, this is a re-po, WE WILL NEGOTIATE. Located in Beaumont, TX.
Left hand discharge, with 24" 2 auger discharge, and magnet tip off. Not the nicest looking, but will do the job. Comes with scale head, ladder, 1 3/8 21 spline PTO, and airplane tires.
Financing & Leasing available. Front cross conveyor with hydraulic offset to the right with magnet tip off. Capacity including rubber extension. Can arrange delivery. For more info contact Sales (888)840-5582, or by email.
✓ allowing for supreme cutting and excellent discharge leaving you with a superior cut. The reinforced leading edge provides protection where the mower deck needs it most.
COMFORT
The deep cushioned 18-inch high-back seat
✓ unmatched power and durability. Featuring cooling fans and a robust planetary gear reduction
✓ comfortable operation.
EASY ZERO TURN MAINTENANCE
Turn the knob on the foot pan to gain access to the top of the deck when zero turn lawn mower maintenance is needed
✓ giving you a smoother ride at faster mowing speeds.
FABRICATED DECK
An innovative grass cutting system has the center point offset
✓ allowing you can get back to the job quickly and easily.
REAR BUMPER
Three steel bars wrap-around the rear of the zero turn protecting the mower engine and operating components from damage.
✓ Brand New Zero Turn 61" cutting width
VANGUARDtm 810 ENGINE
At an optimum 810cc
Mixer comes standard with the 2 speed split drive gearbox, and has the optional 2 speed shift cable on it. Front cross conveyor with 36" chain, and slat discharge extension with magnet tip off.
