Used Equipment New Holland Skid Steers For Sale In Cross Plains

80 HP 2000 LB OPERATING LOADE 3190 HOURS .. ENCLOSED CAB W/ HEAT AND HAS AC BUT DOES NOT WORK , HYD COUPLER,FOOT THROTTLE,2 SPEED,AUX HYD W/CASE RETURN ,, 12X16.5 TIRES WE JUST INSTALLED 2 DRIVE MOTORS

SKIDLOADER W/ 56HP AND 1500 LB OPERATING LOAD, ,, 1885 HOURS,ENCLOSED CAB W/HEAT,SINGLE SPEED,AUX HYD, ,, NEW 10X16.5 TIRES,FOOT THROTTLE,NO BUCKET

Case coupler for 75XT or 435 SKID

72" LOW PROFILE EXTENDED LIP BUCKET W/WELD ON TEETH , AND MOUNTING PLATE MPUF-3 TO ALSO FIT 1840

74" material bucket

72" EXTREM 6" DIAMETER BRUSH CUTTER OPEN FRONT , 20-30 GPM NO CASE DRAIN

ON SHELFS SOUTH SIDE IN . PILOT CONTROLS THAT WAS IN A R220 TAG 42400 .7 THIS SKIDLOADER WAS CHANGED OVER TO DUAL HAND CONTROL ,, KIT IS IN QUONSET BUILDING.

HAYHEAD WAS ON NH 900 CHOPPER

AUTOMATIC HYDRAULIC HITCH FOR SEVERAL NEW HOLLAND & CASE IH FORAGE HARVESTERS

HAYHEAD OFF NH230 CHOPPER

SINGLE AXLE,CROP PROCESSOR AND METAL DETECTOR 1"3/8 PTO 14LX16.1 TIRES HYDRAULIC SWING TOUNGE

Hay head w/paddle auger

NEW HOLLAND HYDRAFORMATIC BALE TENSION KIT FOR SEVERAL BALERS

HAYHEAD OF FP230 NH CHOPPER

CHOPPER W/1"3/4 PTO,CROP PROCESSOR,TANDEM AXLE METAL DETECTOR,HYD TOUNGE SWING. 6 KNIVES 29P HAYHEAD TAG 40179 SER NUM YBN063794.

HAYHEAD 6'6" TINE TO TINE WAS ON 230 NH CHOPPER

CHOPPER W/METAL AND PROCESSOR 1"3/8 PTO 14LX16.1 8 PLY TIRE HYD SWING TONUGE

5X5 ROUND BALER W/ELECTRIC TWINE TIE ONLY, , 540 PTO,5FT PICKUP,31.5x13.5x15 TIRES

13FT DISCBINE W/RUBBER ON RUBBER ROLLS4 DRAW BAR SWIVEL HITCH QUICK CHANGE KNIVES

13FT DISCBINE W/RUBBER ON RUBBER ROLLS4 DRAW BAR SWIVEL HITCH QUICK CHANGE KNIVES

13FT DISCBINE W/RUBBER ON RUBBER ROLLS DRAWBAR SWIVEL HITCH QUICK CHANGE KNIVES

10'4" DISCBINE W/RUBBER ON RUBBER ROLLS HYD TONGUE SWING AND HYD HEADER TILT STANDARD TONGUE 540 PTO

10'4" DISCBINE W/RUBBER ON RUBBER ROLLS HYD TONGUE SWING AND HYD HEADER TILT STANDARD TONGUE 1000 PTO