Used Equipment New Holland For Sale In Albany

TANDEM AXLE, ROLLER CHUTE,, CHAMBER LINER: BALE EJECTOR

4x6 Bale, Rotocut, Twine & netwrap

3X4 ROLLER CHUTE CHAMBER LINER, SINGLE AXLE

High idler tracks, Pto, 3 Point, Cab suspension, HID lights, WAAS Guidance, High capacity drawbar, 6 remotes, 57 gpm hydraulic pump, Power beyond, Radar, Powertrain extended warranty expires 2/6/2020 or 4000 total hours Cab, Air, Heat, Radio, GPS, Ground...

Hyd.; Pin-On Bucket; 27.5" Pads; 8'6" Dozer Blade; Auto Idle; ECO Working Mode; iNDr Integrated Noise and Dust Reduction System; 2-spd. ***See the other ABELE TRACTOR listings for over 1,000 machines and attachments to purchase or rent.*** A/C Condition:...

***Need a Harley Rake?! Check out more ABELE TRACTOR listings for over 1,000 machines and attachments available for rental or purchase*** We have here a really nice low hour New Holland that has been well cared for.

13' cutting width, Flail conditioner

LINER, EJECTOR, LARGE MONITOR, TANDEM AXLE ROLLER CHUTE

This unique set up allows you to get into and over places other brush mowers can't get into. The best machine to buy is one you know. PLEASE NOTE: the our meter was changed at 1058 Hours, The current meter reads 579hrs which put a total of 1,638 Hours...

STK# 17115593: 2012 New Holland TS6020 Tractor, 110HP FPT NEF Tier III Eng., 90HP PTO, Cab w/HVAC, 4-WD, 12x3 (8x2 Creeper Range) Constant Mesh Trans., Independent PTO, 14.9x28 Front Tires, 18.4x38 Rear Tires, Tires 85%

STK# 17017282: 2015 NEW HOLLAND POWERSTAR 4.65 TRACTOR LOADER, 65HP, C/H/A 4-WD, 12Fx12R shuttle, 655TL QA Loader, QA Bucket, 11.2x24 Front Tires, 16.9x30 Rear Tires, 2 Rear Remotes,

NICE BALER,STRING TIE,MONITOR

NI 400 & NI 402

1.3YD JRB QH BKT 310

SUPER V TEETH 100 MM 4.0 CYD

4.5 yard GP Bucket, fits too, JRB Coupler - 420 Series

18" HD Trenching Bucket w/ 4 Teeth; Pin-On; 2.30cu.ft cap.; 3-hole arrangement; Weathered but never used; Kubota part# K7867A; Fits* Kubota U25 and U25-3 excavators; *Please verify your machine measurements for accurate fit before purchase

18" HD Trenching Bucket w/ 4 Teeth; Pin-On; 3.23 cu.ft cap.; 3-hole arrangement; Weathered but unused; Kubota Part#K7843; Fits* Kubota KX161, KX161-3, U45 and U45-3 excavators; *Please verify your machine measurements for accurate fit before purchase