Used Equipment Mowers For Sale In Minnesota

Less than 120 Hours on it. Used John Deere LX277 with Snow Thrower, and spreader. They were 50, 100, 125, and 175 Ft long. Bought new in June 2003. We had heavy snow this last winter, and the Thrower was very handy in digging us out.

30\\" cutting span - must sell due to my poor health - have not run the mower for the past two years - Excellent condition - New battery just put in - has mulcher - only used for 2 years

Cleanest one you will find , very light use and always in the shed

Case IH DCX161 16' Disc mower conditioner, Steel cond rolls, Swivel hitch

2018 Case IH MD72 (HD) Disk mower demo unit 1 acre only 1 left

7'9" wide; 3 pt; 540 PTO

11'6" CUT WIDTH, DRAWBAR HITCH, HYDRAULIC SWING, ROTARY DISK CUTTERBAR, URETHAN CONDITIONER, 1 3/8" PTO, CUT BAR SHEAR PROTECTION, MANUAL CUTTING BAR ANGLE, 31l x 13.5 TIRES, ONE OWNER, LOCAL TRADE, SUPER CLEAN, CALL KYLE FOR MORE DETAILS AT 507-215-4341...

Used 2012 New Holland H6750 Disc Mower, 9'2" Cutting Width, 7 Disc Assemblies.

9'2" CUT WIDTH, 7 ROTARY DISKS, HYDRAULIC LIFT, 540 PTO, AVERAGE, ONE OWNER LOCAL TRADE - VISIT OUR WEBSITE DEEREQUIPMENT.COM TO VIEW OUR INVENTORY ONLINE.

30 ft, has front mower claas 3100frc sn#63901571, hydraulic float front & rear mowers, quick change knives

60 INCH FINISH MOWER 3PT WALCO

Mower 22" Minimum: $25.00 Hourly: $10.00 Daily: $60.00 Weekly: $180.00 Lawnandgarden

60HP/HYDRO/12' MOWER/RWD

2018 New Holland 316

9'3" sickle, cut, side pull, rubber conditioner rolls, hyd swing, recently had a new sickle installed

37 HP DIESEL COMMERCIAL FRONT MOWER WITH 72" SIDE DISCHARGE MOWER DECK, 4 WHEEL DRIVE, TWO SPEED HYDRO, 2 HYD SPOOLS FOR IMPLEMENTS, AIR RIDE SEAT

1997 New Holland 1431 $10,800.00

16ft hydra swing, 3" sickle, 1000 rpm 1 3/8" pto pump, hitch straight, reel very nice, bars straight, tines good, 1 rubber 1 steel roller, straight but a little faded

Type: 20 Ft • Type: Wing-Fold

Counter-Rotating Three-Bladed Discs: With three blades per disc Kubota mowers are constantly cutting. Recommended HP: 36 PTO hp This means a third less load per blade; an even load on the drive; smoother power usage; and produces an even, cleanly cut...