Used Equipment Aggregate Equipment For Sale In St George

Mobile 3 Deck Screen. CAT Diesel Engine. Maximum feed capacity approximately 500 t/h.

Mobile Track Mounted Jaw Crusher. Feeding Capacity up to 300t/hr.

ROPS CANOPY,GOOD RUNNER, CHAINS AND SPROCKETS 85%, FLIGHTS HAVE BEEN BUILT UP Hours need to be verified

Trailer Mounted 8" Pump, Deere 4045 Engine Pump is operating at 50-60% efficiency. Pump will need to be rebuilt and sealed eventually. Comes with: 20' of 8" Hose 70' of 6" Hose 150-200' of Discharge Hose Butterfly Valves and Bauer Fittings

15" Wide Bucket.

24" Bucket, Good Condition 15" Length of PinCenter to Center Sitting in St. George, SC yard

Stump Puller/Shear/Splitter

HYDRAULIC Thumb, Good Condition. See dimensions below. Could fit other units outside of Volvo.

CAT BROOM FOR SKID-STEER, 1-OWNER, READY TO WORK

Drive Axle for Volvo L150C Loader.

3 Pin Holes 1" pin Holes 18" Wide 271/2" Length

23" wide 38 1/2 length Front Holes 21/4 pin size Rear Holes 2" pin size 13 1/2" Outside mounting pin Bracket 10" Inside mounting pin Bracket

A30D Beds with Cylinders 3 AVAILABLE

BUCKET FOR CAT 330 SIZE MACHINE, TEETH AND SIDE-CUTTERS, GOOD SHAPE

Two 4' compactorsex DOT. Good Condition.

Forestry Grapple.

24" wide bucket 18" Deep bucket 1' Pins 71/2" center of pins 41/2" Inside width pin mount 8" overall width pin mount 5-Teeth

35" HEAVY DUTY BUCKET FOR A CAT 320, GREAT SHAPE, USED VERY LITTLE

COMPLETE TOPCON AUTOGRADE FOR ASPHALT PAVING, GREAT CONDITION, READY TO GO

BOBCAT SKID STEER AUGER THAT FITS MOST SKID STEERS, IN GOOD SHAPE AND COMES WITH 1 BIT

60" Clean out bucket. Good Condition 18" Pin LengthCenter to Center Sitting in St. George, SC

ROPS CANOPY WITH SEMI-U BLADE, 75% UNDERCARRIAGE, GOOD RUNNING MACHINE

Pump was running when taken out of service. Tires are weak. Been sitting for 3 years. Perkins engine.

Has extra hydraulics. Motor is bad and it comes with no digging bucket.

Screed, new extensions, runs good Buyer to confirm year