Used Equipment Aggregate Equipment For Sale In Brookshire

Balderson Blade with Quick Connect for Wheel Loader 988 In good condition was used with a 988F wheel loader.

Fits Caterpillar 140H, 143H, 160H, 163H, 104G

This trailer has been sand blasted and has fresh paint, the liner on the inside is brand new, just lined. Butterfly valves and flange valves are brand new. 2007 Troxell 130 BBL Kill Trailer / Vacuum Trailer, 2 compartment 40/90 split,Carboline Plasite...

Spring suspension. Works good, good rails. Solid frame, no rust or dents, etc. 1999 Galbreath Model: A5-OR-402 Roll Off Trailer, Tri-axle with big tires, 30,000lbs G.VW.R, 21,200lbs G.A.W.R., cable hoist roll off, 5th wheel.

6 x 14.00 x 24 Tires Only @ 50% Remaining.

Both Blade and bucket for 988B

Complete With Mounting Rods. Original Cat Multi Shank Ripper Came Of A 140H Has 3 Cat Ripper And 8 Cat Scarifier Shanks, In Excellent Conditoin .

Truck sells DOT inspected, ready to work. Fresh paint all around, good tires. Stainless steel NVE air activated and manual safety valves in the rear, DOT approved. These trucks will haul grease, septic, water, sludge, mud, and HAZMAT material for your...

Vacuum pump and operational equipment is all working, new valves in the rear, new wing nuts for the manway hatches top of tank and rear manway. Sells DOT inspected. 2011 Peterbilt 367 Tri-Axle Vacuum Truck with 238,000 miles.

2006 Mack CHN613 Vacuum Truck with 413,000 miles. Mack 427HP engine, eaton fuller 13 speed, NVE vacuum pump with transfer gear pump too, tandem axle, air ride, 3,500 gallon vacuum tank, 3.90 ratio, 230"in wheelbase, 12,000lbs fronts and 40,000lbs rears.

Spring suspension, heavy spec, double frame. Truck has no check lights, no air leaks, no oil leaks, no broken panels or switches. I have several kill trucks available. Truck is powered by the very reliable and legendary Mack E7 engine.

Water heater boiler. Fresh engine oil change. A/C Condition: Excellent, A/C, Differential Lock, State DOT, Lift Axle, Lift Axle Type: Mid Absolutely gone through by us, all agauges working in control panel and inside cab, no check lights, no hydraulic...

2008 Traileze 4 axle Lowboy/ RGN/ oil field trailer, 25,000lbs each axle with air lift on 1st and 4th. OVERALL LENGTH : 59'-8" MAIN DECK LENGTH : 45' UPPER DECK LENGTH : 14'-6" WIDTH : 102" SWING CLEARANCE : 102" - 120" KING PIN SETTING : 16" - 34" DECK...

G&H 60,000lbs roll off cable hoist. 2004 Mack CH613 Roll Off with 297,000 miles. Leather seats, cruise control. This truck is ready to work and get the job done. Truck sells DOT inspected, fresh tires all around, no check lights, all gauges in the cab...

Hendrickson Walking beam suspension, 20,000lbs fronts and 58,000lbs rears. Truck is ready to work, all winches are working, no check lights, no air leaks or oil leaks. A/C Condition: Excellent, A/C, State DOT, Headache Rack, Turbo

Heavy specs, double frame, 20,000lbs fronts and 46,000lbs rears. This is what we do. Cab and chassis. Brand new valves all around, fresh tires all around, fresh sandblast and paint all around.

One has 60k miles and the other has 102k miles, Cummins ISX 475HP, Eaton Fuller 18 speed, Gardener Denver TEEAC 5,000psi pump, MCM 3X4 pump, NVE Challenger 367 vacuum pump, NuFlow Meter Analyzer.

Blower hours are 3,002 hours. Caterpillar C-13, 25,000 miles, eaton fuller 10 speed, Engine hours are 5,102 hours. All gauges in control panel working and inside cab, no check lights, or leaks.

All fully working. 2012 and 2013 Kenworths T800 Ramvac HX-12 Hydrovac with low miles from 20,000 to 80,000 miles. Temperature enclosed cabin with blower, water quintuplex pump and heater boiler stored in there.

With 14,000 original miles (computer verified) and 8,000 hours. 2005 Sterling Vacuum Truck DOT CODE/HAZMAT/ 407/412. Has NVE air safety valves on the rear. Powered by a very powerful Wittig vacuum pump.

COMES EQUIPPED WITH 5 SHANKS IN STOCK READY FOR DELIVERY. MADE IN USA NEW / UNUSED SCARIFIER NEW UN TO FIT 140M, 12M, 160M .

Good Tires All Around, Has A Blower

It has full rolling tailboard, hydraulic Tulsa 45,000lbs winch and a hydraulic NVE 367 Challenger vacuum pump, 14,000lbs fronts and 40,000lbs rears. Will have aluminum wheels all around.

353,000 miles, Maxitorque 13 speed transmission, Tulsa 45,000lbs hydraulic winch and has 2016 Jurop PN84 vacuum pump, leather seats, chrome exhaust, half roller tailboard in the back, Mack 427HP engine, aluminum tanks, aluminum front wheels, 90% tires...