Shut-off plugs and parts available separately. High-quality stainless steel wash valves include two high-density polyethylene paddles, one short paddle which allows milk to flow into receiver, and one long paddle which blocks wash water.
This CIP Assembly for Surge features Stainless Steel jetter rack and 120116 jetter cups. Like our other CIP Kits, it also includes Smooth Approved Barbless Tee, Duckbill Drain, U-Bolts and Nuts for installation.
LEDs are added to help diagnose washer trigger supply issues. 115 volt 60 HZ. Each pump has a multi-time module to program on/off, run times and delay times from 1 second to 45 minutes.
Coburn"s S.S. Distributor Tee with vent hole is smooth and clean throughout for efficient water flow. Tubes are aligned for ease and convenience of hose handling.
This CIP Assembly for BouMatic features Stainless Steel jetter rack and 120117 jetter cups. Like our other CIP Kits, it also includes Smooth Approved Barbless Tee, Duckbill Drain, U-Bolts and Nuts for installation.
Hardware is included. Stainless Steel Fit ‘em All Heavy Duty Jetter Rack will hold virtually any milking claw including Delaval. CIP components are sold individually, or as part of complete kit.
Thermometer registers from 1 to 220F and the face is 1" diameter with a 5" stainless steel stem. CIP Thermometer is used to make sure the CIP wash solution is at the required 160F degrees at the start of the wash cycle.
90 Degree Sweep Ell is made of Type 304 Stainless Steel with #4 Dairy Finish and features standard clamp fitting on one end and butt weld on the other. Ell for 2" OD tube features "A" dimension of 4-1/16" and "B" dimension of 4-9/16”.
90 Degree Elbow is made of Type 304 Stainless Steel with #4 Dairy Finish and features standard clamp fitting on both ends. Elbow for 2" OD tube features inner radius of 3" and center distance (C) of 3.5".
Includes 1 head O-ring, 2 impeller clips, 1 ceramic ring assembly and 1 carbon seal assembly. External Seal Kit. This kit is for the LC Thomson Model 5 Milk Pump.
Concentric Reducer is made of Type 304 Stainless Steel with #4 Dairy Finish and featuresstandard clamp fitting on both ends. Reducer from 4" OD to 2.5" OD tube is 7-1/8" long.
1-7/16" long for 3" OD tube. 1-1/8" long for 1.5" OD tube. Plain Recessless Ferrule for standard clamp is made of Type 304 Stainless Steel with #4 Dairy Finish. 1-3/16" long for 2" OD tube.
Concentric Reducer is made of Type 304 Stainless Steel with #4 Dairy Finish and features butt weld fitting on both ends.Reducer from 4" OD to 2.5" OD tube is 6" long.
Short Weld Ferrule is made of Type 304 Stainless Steel with #4 Dairy Finish and features threading on one end and butt weld on the other.Ferrule for 2" OD tube is 23/32" long.
