This unit is insulated with 3 1/2" of polyurethane insulation. The peaked roof and raised ribs around the door openings prevent manure, feed and other contaminants from being washed into the bowl, and facilitates water run off.
Connects to 3/4 garden hose or adaptable for pipe. This Dare farm tank float valve with aluminum housing has a 300 gallon per hour capacity and a tough blow-molded plastic float. We stock all replacement parts.
Used to insulate the Heat Well below the frost line, preventing the loss of energy into the frozen ground. Unaffected by ground movement due to freezing & thawing. 15" OD, corrugated plastic tubing insulated inside with Urethane foam to a 10" ID.
Used to extend the Insulated Earth Tube into warm ground below the frost line & form the Heat Well. Unaffected by ground movement due to freezing & thawing. 15" OD, corrugated plastic tubing.
Unique covered design aids in eliminating debris from contaminating the water supply Holds 2 gallons Bottom drain for easy cleaning Can be attached to timber rails, wall, pipe rails or steel gate Includes 4 self taping screws & 4 cable ties for installation...
This is the arm that opens & closes the plunger. #2 on breakdown. Pride of the Farm Cam Link locks to the VP124 valve body on the top side with a link pin. No other parts come with the Cam Link.
Made of nylon and fibreglass. This economy tank-side mounting bracket fastens securely with a thumb screw and bushing--no tools needed! Connects directly to garden hose, and fits all standard tanks and some plastic tanks.
This exchange of water keeps the water warm even in the coldest climate. 33" X 58" X 19" Each model comes with anchors for mounting to concrete pad, pipe insulation, and a section of 3/4" PVC pipe.
The cavity can be used to make the connection from the supply line to our valve. Simple water level adjustment, easy to clean. Some warm geographic areas do not use a riser tile and may only have a buried supply line protruding through a concrete pad.
Two Year Warranty High Volume - 2400 GPH at 40 PSI Animal Damage-Resistant Design No Float Ball or Moving Parts Unaffected by Freezing Hudson Valve for 1-140 PSI with 1" female thread is 5" high and 3.75" in diameter.
Pride of the Farm Plastic 3 5/8" Float arm is connected to the Power Link by a thumbscrew & then screws directly into the Poly float. #12-3 on the breakdown. This part number is for the arm only & is usually used on the Polar Max waterers.
The Tru-Test Apex Xtraflo 3/4" Trough Valve Long Tail is a full flow - diaphragm activated, armless, self-cleaning valve mechanism, with a longer valve end. Minimum inlet pressure 5 PSI, Maximum inlet pressure 150 PSI.
35-Gallon Water Tank, small enough you can tip over to drain (does not have drain plug). 5-year warranty. Measures 37” x 27 1/2” x 13”, ash grey color.
3 year warranty. Available in Aqua Blue color only. 40 1/2" x 28 1/4" x 14 1/4" The larger tanks come with 1.25� drains installed. All edges have been rounded for safety & strength.
New sleek design tanks work for three different applications. Constructed of an FDA-approved plastic. The Lay Down tank is an easy way to haul water on the floor of your trailer or in the back of a pickup.
The High Country Plastics TC-63 Pickup Bed Water Caddy is an innovative way to haul up to 63 gallons of fresh water in your pickup truck while still allowing for easy hook-up to a gooseneck trailer.
✓ Weight: Approximately: 55 pounds
✓ Shipping Dimensions: Approximately 60.25 x 21 x 18.5 inches. (oversized)
