Livestock Waterers Farm Supplies For Sale In Odessa

Fluid level forces the float to rise and close the diaphragm chamber, which expands to stop incoming flow. Valve body parts are made out of a durable glass-filled nylon, which is vented to eliminate siphoning.

This piece is held by two thumbscrews not included in this part. 6 1/2" orange arm that fits between the lower arm and the float connect.

An Earth Tube is suggested with installation. The low profile design & fully hinged door provids animals better access to the capacity of the water & combination water gasket & foam gasket ensures an airtight seal between the lid & base.

Robert's Brass 3/4" orifice Valve complete with plunger and arms. The R400 series is a high-capacity float valve with male NPT inlet and outlet connections. This model features an adjustable short arm for customizing water level.

Inside repair kit for Topaz & Megaflow Valve.

Hay rack not included. Tanks measure 63 1/2" L x 18" W x 12" deep. New sleek design tanks work for three different applications. (Manufacturer recommends also securing with ratchet tie downs.) Clear plastic allows you to see the water level easily.

Replacement Low Pressure Valve for Miraco waterers.

Megaflow Float Valves are ideal for filling troughs which are constructed to have the valve mounted under the water on the side or on the bottom. Features High flow Compact robust construction 3/4″-2 1/2″ water level differential (increases as water...

Robert's Brass 1/2" orfice Valve complete with sand plunger and arms.

They are made for tanks which have the valve mounted above or below the water. Features Has Detach for quick access to valve seal Mounts horizontally or vertically Made from corrosion resistant materials Shuts down slowly to minimize water hammer 3/4″-2...

The ground mount tube ONLY provides some cold weather protection to your barn stall waterer (not included), but you may need to add heat tape to the water supply line. Both the water line & the electrical supply can enter from below.

Johnson Waterer Element Clips to hold the heating element.

It is held by a float screw and connects on to the bottom of the float arm. Plastic piece that sits on top of the float.

No pulleys & cable to foul & rust. Livestock can drink out of both flaps at the same time, not always so with a ball closure. Double wall DURAROCK construction contains hindered amine light stabilizer, the most effective ultraviolet inhibitor.

2" built in drain, stainless steel spring loaded attachment pins make cover removal & replacement easy, recessed, protected notches for secure anchoring, 250 watt heater, overflow port & dependable non-siphoning Durapride Valve.

The Trough-O-Matic float valve features a longer, deeper float which gives more leverage. Water pressure and has a capacity of 375 gallons per hour. Valve works with up to 70 lbs. The rust-proof plastic cover is fitted with a 3/4" female hose connection.

SPI 2 1/2" Brass Short Float Stem only.

Same description as J101 EXCEPT THIS UNIT HAS NO HEAT.

Suggested where sugar sand is a problem in the water supply. Robert's Brass 3/4" sand plunger only for replacement in existing 3/4" valve.

Replacement drain plug for MiraFount Waterers.

Horseshoe shaped 285 Watt element used in all Franklin galvanized waterers.

A round float for Arkfeld,SPI or Mira Fount waterers.

Includes 3/4” hose attachment and metal brackets for installation on a fence or wall. U-bolts are not provided. Optimum pressure range is 20 to 50 psi. Ideal for horses, cattle, dogs and other similar sized animals.

Use this valve assembly with the J303 with without heat.