Livestock Waterers Farm Supplies For Sale In Naperville

The inside base of the Franklin Valve. This piece holds the plunger and upper arm. No inside working parts included.

40 Watt x 36" Heat Tape used in the Energy Efficient & All Purpose waterers.

SPI 90 degree elbow for all models.

Capacity is one-half pint (1 cup). Polyethylene Cage Cup has molded-in hooks to clip onto the side of any type of wire animal cage. Useful for feeding or watering rabbits, poultry or any type of small animal.

Valve works with up to 70 lbs. The Trough-O-Matic float valve features a longer, deeper float which gives more leverage. The rust-proof plastic case comes with an adapter to fit a 3/4" male or 1/2" female pipe.

Pride of the Farm Plastic Thumb Screw that connects the Power Link & the Float arm (not included). #11 on breakdown.

A drain plug for Arkfeld waterers - 2" in size - Cork.

The Model HE-CNTRL air sensing thermostat is a replacement for the original "bulb and bellows" thermostat, used to protect from freezing your Hawkeye Steel livestock waterer. It will turn on the heating element at 45 degrees Fahrenheit and off at 60 degrees...

A brass rod float arm 1/4" x 2" with threads on each end. Connects valve to 301 round float.

A brass rod float arm 1/4" x 12" with threads on each end. Connects valve to 301 round float.

There are no loose parts. Our drinker has foam filled double wall construction which adds to the efficiency. You can expect an entire winter's heating bill of $25.00 or less - and this from a drinker that can water 250 head of beef using only 250 watts.

Capactiy: 250 head of beef, 120 head of dairy or 200 cow/calf pairs. This unit features removable end panels to help get new cattle started fast or to provide more capacity for a few extra head.

Center of water tank tapers down in the middle for visibility. Features 4 built-in cup holders to hold drinks or spray bottles, and a center storage area with lid to store miscellaneous items.

The Tru-Test Apex Xtraflo 3/4" valve with brass rod arm attached to the black round float for Anti-Siphon use.

3-year warranty. Comes standard with two shut-off valves, one for hose and the other for filling a bucket. Constructed with FDA-approved materials, with a vent in the fill cap on top of the caddy.

Water and electric lines run underground below frost line. The 303 Riser Tube protects the water supply line from the cold by insulating it in urethane foam, and warming it with a low wattage heating element.

3/4" male to female hose used to hook up the water line to the waterer.

Blue 10 3/4" replacement ball for the Mira Fount 3354S, M3370S, M3390, M3390E cattle waterers & 3360-10 hog waterer.

With quick release access clips for the hatch cover and access doors, installation and work is a lot quicker. 5 year warranty. The new Value Series waterers from SPI are a "no tools required" waterer.

Continuous flow disc and repair kit for use with Hudson valves.

All edges have been rounded for safety & strength. If the tank gets a small leak due to unforeseen circumstances, such as a bullet hole, it can be braze welded with a common butane torch to fill the hole.

Black rubber seat to fit inside the Mira Fount RED Plunger in a Mira Fount cattle waterer valve.

Used for joining multiple Earth Tubes. It is a split plastic coupler that fits into the corrugation of the Earth Tube.

(30 years of use) A typical annual heating bill with Model WPO12 might be somewhat higher than with Model WPO17 - maybe $15.00 instead of $10.00! Model WPO12 has the same foam filled double wall construction.

Has a 3-year manufacturer's guarantee. Also comes with two tie straps. Constructed of an FDA-approved plastic, the Hay Rack Water Caddy comes with a 8' hose kit and shut-off valve to allow filling from the ground.

The upper arm is orange and is located in the top bracket of the top base and is held by a lock pin. It moves the plunger to and from the orfice.

Available in Forest Green in stock, also available in Ash Grey, Black, Blue, Red & Tan colors for special order. All edges have been rounded for safety and strength. The one piece construction eliminates cracking & splitting common in plastic-welded,...