Livestock Waterers Farm Supplies For Sale In Lincoln

White styrofoam round disc float only.

SPI hatch cover for model 4x4 energy free waterer.

SPI foamed door only. Specify model 354, 352 or 351 energy free waterer.

250 Watt, 110 volt heater. Typical heating cost for one heating season only $10!

3" orange arm that fits between the lower arm and the float connect. This piece is held by two thumbscrews not included in this part.

Unit is unnoticed by livestock - no cord in water. Easy to install & installs in only minutes. Custom made to use in all Rubbermaid stock tanks with 1500 Watts of power. Thermostatically controlled to only run when necessary.

Stainless steel access plates. THE RACE IS OVER. Half moon design on back corner for securing up to a 2 inch (5.1 cm) PVC tube for plumbing from above or below. Simple water level adjustment, easy to clean.

The lower arm is orange and is located in the bottom bracket of the top base and is held by a lock pin. It moves the upper to and is also held by a thumbscrew to the float arm.

Megaflow Yellow Float Only.

VP2 Valve Upgrade Kit for 1/4" Orfice Valve

Water and electric lines run underground below frost line. The 303 Riser Tube protects the water supply line from the cold by insulating it in urethane foam, and warming it with a low wattage heating element.

Pride of the Farm Plastic Plunger that fits directly into the VP124 valve body & the rubber diaphragm. #5 on breakdown.

Heating element ONLY for all Johnson Concrete Models EXCEPT the J360.

Waterers work on the same principle as a thermos bottle. Now a waterer that requires no electricity, so it saves 100% of your energy costs. The floats seal the water away from outside.

Blue plastic valve assembly fits a 3/4" FPT with a .25" orfice inlet. Mostly used on cattle waterers such as Franklin, SPI & MiraFount and Pride of the Farm.

A brass rod float arm 1/4" x 1 1/2" with threads on each end. Connects valve to 301 round float

#12-3 on the breakdown. Pride of the Farm Plastic 3 5/8" Float arm is connected to the Power Link by a thumbscrew & then screws directly into the Poly float. This part number is for the arm only & is usually used on the Polar Max waterers.

Two Year Warranty High Volume - 2400 GPH at 40 PSI Animal Damage-Resistant Design No Float Ball or Moving Parts Unaffected by Freezing Hudson Valve with European Thread for 1-140 PSI with 1/2" female thread is 5" high and 3.75" in diameter.

Unique covered design aids in eliminating debris from contaminating the water supply Holds 2 gallons Bottom drain for easy cleaning Can be attached to timber rails, wall, pipe rails or steel gate Includes 4 self taping screws & 4 cable ties for installation...

Blue plastic valve assembly fits a 3/4" FPT with a .45" orfice inlet, includes arm that will fit any length, 2 thumbscrews & plastic float. Mostly used on cattle waterers such as Franklin, SPI & MiraFount and Pride of the Farm.

It has an above water float adjustment, cord cleat for shutting off valve and a 1 1/2" water level differential from open to close. You can mount this valve on the bottom or on the side and has a bouyancy equal to a 6" round float.

Water pressure and has a capacity of 375 gallons per hour. The Trough-O-Matic float valve features a longer, deeper float which gives more leverage. The non-corrosive metal case is fitted with a 3/4" female hose connection.

This model features an adjustable short arm for customizing water level. Robert's Brass 3/8" orifice Valve complete with plunger and arms. The R400 series is a high-capacity float valve with male NPT inlet and outlet connections.

XtraFlo is UV stabilized and corrosion resistant. The valve has a 1” water level differential between opening and closing, reducing pump motor overload. XtraFlo compact diaphragm valve has full-flow, high volume fill.

The water line is typically run underground and up through the 303 Riser Tube. Like all models of the JUG, the 303 has the unique, patented Draw Tube Feed Trap which keeps debris from falling into the reservoir.

Dimensions: 25" x 20" x 23". Features: *Open bowl design *Draw Tube for natural drinking action *External Drain Plug for easy cleaning *Sledge hammer tough, rotationally molded plastic construction *Inspection cover for easy access to float valve *External...