Livestock Waterers Farm Supplies For Sale In Clearwater

Connects to 3/4" garden hose or adaptable for pipe. We stock all replacement parts. This Dare anti-siphon farm tank float valve with aluminum housing has a 300 gallon per hour capacity and a tough blow-molded plastic float.

The Jug Basic Float Valve fits Models J101, 202, 303 & 404 with or without heat.

3/4" orfice only for the inside of a Franklin Valve.

Fully submerged valve is almost indestructible to livestock and models come in standard tail length and long tail length. The top entry model provides an air gap, preventing back-flow.

Won't rust, resists rot & holds up to chemically active soil conditions. Unaffected by ground movement due to freezing & thawing. Used to extend the Insulated Earth Tube into warm ground below the frost line & form the Heat Well.

These are not included when ordering a base only. There are four base screws that hold the top base to the bottom base.

A round float for Arkfeld,SPI or Mira Fount waterers.

This unit fits the Model 101, 202 & 404 with or without heat.

1 per model EXCEPT 404 models need 2 kits. Weather seal Kit for Jug 101, 202 & 404 with or without heat.

It is held by a float screw and connects on to the bottom of the float arm. Plastic piece that sits on top of the float.

Robert's 1/2" rubber cup ring that fits on the brass plunger.

45 Gallon, 48" x 35" x 25" - 1345# All J Models Heavy duty concrete tank (reinforced with rebar and fibermesh Safe, quick and easy to lift and set Epoxy painted trough and outside Chamfered edges Notched top for controlled overflow Brass or plastic water...

B79P Plastic Float with Arm for WFD85 and MFD85 field drinkers. B79P includes:Ref. 14, 15, 16 in parts list.

After 3 weeks of use, we have no leaks or overflows. I was purchasing to replace an older one that finally wore out. I have 2 on troughs for cattle and one for the dogs. The dogs chew on everything so I used the metal housing.

Spring loaded pin allows access panel to pop off with the twist of a screwdriver. You can expect an entire winter's heating bill of $25.00 or less - and this from a drinker that can water 250 head of beef using only 250 watts.

The WPM80 is an extremely rugged 4 door opening, energy free unit for cattle. Seamless sidewall cannot leak. Nature's ground water temperature does this job. Notched flanges for easy anchoring.

Two Year Warranty High Volume - 2400 GPH at 40 PSI Animal Damage-Resistant Design No Float Ball or Moving Parts Unaffected by Freezing Hudson Valve with European Thread for 1-140 PSI with 1/2" female thread is 5" high and 3.75" in diameter.

The Tru-Test Apex Xtraflo 3/4" valve with brass rod arm attached to the black round float for Anti-Siphon use.

This quick release "D" clip is used on all of the New Generation Energy Free Waterers (4 per Unit) & on the Electric Waterer's inspection plates.

This Jug 4 Hole Waterer has a 45 gallon tank capacity & waterers 125 head of Dairy, 250 head of Beef & 300 head of Sheep. It's maximum 24-hr electical use is 1.56 kwh. Features: *Open bowl design *Draw Tube for natural drinking action *External Drain...

Provides just the right height to fill buckets without a hose. Includes storage compartment. Not compatible with 39 Gallon Upright Water Caddy (36960) or 18 Gallon Water Caddy (34021).

Black rubber seat to fit inside the Mira Fount RED Plunger in a Mira Fount cattle waterer valve.

Has 2” to 3” urethane foam insulation. 30.5” x 16.5” x 27” tall. Sloped bottom for easy clean-out. Approximately 48 lbs. 19” drinking height. Removable dome for quick and easy access to valve area.

Mostly used on cattle waterers. Blue plastic valve assembly fits a 3/4" FPT with a 3/4" orfice inlet.

The WPM14 is an extremely rugged 4 door opening, energy free unit for sheep or calves. Seamless sidewall cannot leak. Nature's ground water temperature does this job. Notched flanges for easy anchoring.