Livestock Waterers Farm Supplies For Sale In Calgary

The orange cap only that fits over the insides of the Franklin Valve.

B79P Plastic Float with Arm for WFD85 and MFD85 field drinkers. 14, 15, 16 in parts list. B79P includes:Ref.

The orange male fitting end of the Franklin Valve. No inside working parts included.

Robert's 1/2" rubber plunger seat only.

The D-Clip features no tools required to remove lid, no crossed/stripped thread failures, quick replacement if damaged & commonly available at farm supply stores. Drinking height is 15" Door Opening is 9 1/2" x 9 1/2" and trough holds 17 gallons of water.

Corrugated design provides rigidity without bulk when back filled with earth. Used to extend the Insulated Earth Tube into warm ground below the frost line & form the Heat Well. Won't rust, resists rot & holds up to chemically active soil conditions.

40 Watt x 36" Heat Tape used in the Energy Efficient & All Purpose waterers.

A brass rod float arm 1/4" x 1 1/4" with threads on each end. Connects valve to 301 round float.

Blue plastic valve assembly fits a 3/4" FPT with a .45" orfice inlet, includes arm that will fit any length, 2 thumbscrews & plastic float. Mostly used on cattle waterers such as Franklin, SPI & MiraFount and Pride of the Farm.

Pride of the Farm Plastic Plunger that fits directly into the VP124 valve body & the rubber diaphragm. #5 on breakdown.

A brass rod float arm 1/4" x 8" with threads on each end. Connects valve to 301 round float.

SPI 351 (old style) gasket only.

AS VERSATILE AS YOU CAN GET. Large 2” External AND Internal (5.1 cm) clean out drains. Easy access to valve and heater. Some warm geographic areas do not use a riser tile and may only have a buried supply line protruding through a concrete pad.

The WPM80 is an extremely rugged 4 door opening, energy free unit for cattle. Foam insulation between walls has an R-value of 7.14". Optional wing bolts are available for Grade A inspections.

Tank dimensions: 51 1/2" long, 29" wide, 24" high. 1 1/4" pipe plug that will accept a heater or float valve system.

5 year warranty. This two hole, 5.2 gallon waterers uses a 250 or 500 watt submersible heater and can easily ship UPS. 21.75" W x 28" L x 16" H It has double walled foam-filled molded polyethylene construction.

The lower arm is blue and is located in the bottom bracket of the top base and is held by a lock pin. It moves the upper arm and is also held by thumbscrew to the float arm.

The Megaflow is compact, robust and manufactured from non-corroding materials. Its diaphragm principle of operation allows the Megaflow to give flows of up to 90 gallons per minute.

Use this valve assembly with the J303 with without heat.

Arkfeld waterer element & thermostat replacement. 600 watt x 120 volt heating element with surface mount thermostat included.

Blue octagon plunger that fits inside the Mira Fount cattle waterer valve.

This Front Float Valve fits Models 101, 202 & 404 with or without heat.

Repair Kit for Water Control Valves model 825H , 825P , 830H , 830P , 825ASH and 825ASP . Includes seat and float.

This white pin holds the upper arm to the top base.

Unique covered design aids in eliminating debris from contaminating the water supply Holds 2 gallons Bottom drain for easy cleaning Can be attached to timber rails, wall, pipe rails or steel gate Includes 4 self taping screws & 4 cable ties for installation...

Valve 36" Float Cord Only.