Livestock Waterers Farm Supplies For Sale In Anaheim

White styrofoam round disc float only.

Control Diaphragm w/ ABS Stem & Strainer

White styrofoam triangular disc float only.

SPI 351/352 New Generation Gasket.

The low profile design and fully hinged door provides animals better access to the water. Up to 50% more usable water capacity than the competition. The peaked roof and raised ribs around the door openings prevent manure, feed and other contaminants from...

A drain plug for the Arkfeld waterers - 2" in size - Black rubber.

Fluid level forces the float to rise and close the diaphragm chamber, which expands to stop incoming flow. Valve body parts are made out of a durable glass-filled nylon, which is vented to eliminate siphoning.

Robert's Brass 3/4" plunger only for replacement in existing 3/4" valve.

Unique covered design aids in eliminating debris from contaminating the water supply Holds 2 gallons Bottom drain for easy cleaning Can be attached to timber rails, wall, pipe rails or steel gate Includes 4 self taping screws & 4 cable ties for installation...

#10 on breakdown. Pride of the Farm Plastic Nut Only that holds the base & plunger tight inside the Valve Body.

Saves money by using power only when temperatures require. Operates with any 15 amp 120V electric heater or fan. Has many uses around the home & farm. Turns on at 35 degrees & turns off at 45 degrees.

Continuous flow disc and repair kit for use with Hudson valves.

19” drinking height. Sloped bottom for easy clean-out. Removable dome for quick and easy access to valve area. 30.5” x 16.5” x 27” tall. Approximately 48 lbs. Holds 6 gallons.

That gives me peace of mind. I was purchasing to replace an older one that finally wore out. I have 2 on troughs for cattle and one for the dogs. After 3 weeks of use, we have no leaks or overflows.

Features Has Detach for quick access to valve seal Mounts horizontally or vertically Made from corrosion resistant materials Shuts down slowly to minimize water hammer 3/4″-2 1/2″ water level differential (increases as water inlet pressure increases)...

Black rubber seat to fit inside the Mira Fount Blue Plunger in a Mira Fount cattle waterer valve.

Mostly used on cattle waterers such as Franklin, SPI & MiraFount. Orange plastic valve assembly fits a 3/4" FPT with a 3/4" orfice inlet.

Screw that holds the float connect to the top of the float.

The one piece construction eliminates cracking & splitting common in plastic-welded, two piece construction tanks. If the tank gets a small leak due to unforeseen circumstances, such as a bullet hole, it can be braze welded with a common butane torch...

The Trough-O-Matic float valve features a longer, deeper float which gives more leverage. The rust-proof plastic cover is fitted with a 3/4" female hose connection. Valve works with up to 70 lbs.

White polyethylene disc float only.

The brass arm and black round ball float only for an Apex Valve.

Red octagon plunger that fits inside the Mira Fount cattle waterer RED valve.

Plastic screw that holds the float arm to the valve's lower arm at the top and the float connect at the bottom.

This repair kit fits the Models 101, 202 & 404 with or without heat.