Fencing Tools Accessories Farm Livestock For Sale In Nevada

May also be used to terminate the rope at the end of the strand. Connect a fence energizer to 1/4” electric rope or braid. Features a double-post rope clamp connected to a 3/8” terminal with 32” of 12 gauge, shielded wire.

Convenient extra long 68" ground cord. A simple 8-light power indicator for standard or low impedance fencers. The lights are calibrated to illuminate from 625 to 7000 volts.

6-Volt, 12 amp replacement battery for the S40 charger.

Activated when fence pulse is detected Switch to change between DVM and Current Meter modes Retractable voltage probe for reading voltage on energizers and other hard to reach areas Micro-chip technology that enables low voltage operation Detachable ground...

Bolt measures 6” (measured from the 90 degree angle to the point of bolt.) Used with Hot Rope or polywire to turn corners or as an end insulator.

The splicers work perfectly-- never had a problem with them. No complaints whatsoever! I purchased these polytape splicers at the beginning of summer to use on our temporary grazing fencing.

A Reel-Tite is a metal disk measuring 4" x 2 3/4" and made of sturdy 14-gauge steel with plated, weather-resistant finish. Reel-Tites do not break your wire. Mend new and old fence wire in a fraction of the normal time.

Simple design means no breakdown problems yet effectively tighten wire by putting pressure against the post. No cumbersome releases to free wire when finished. This fence stretcher, made of tempered steel, is the last stretcher you'll need to buy.

For use with low impedance fence chargers. Easy-to-read digital design, reads up to 19.9 kilovolts. Matches the performance meter on Parmak fence chargers but will also read all fence chargers accurately.

The Complete 6 ft Grounding Package contains all you need for grounding any electric fence.

1 1/2" Tape Clip, designed specifically for equine electric fence tape to be securely attached to a Gallagher Insulated Line Post.

The 8" tall sturdy metal hub wheel comes with shims for use on gates with less than 1 7/8" O.D. pipe. Works like riding on air! The clamp is a pre-formed piece for a 2" round pipe.