Fencing Tools Accessories Farm Livestock For Sale In Indiana

No wire tying, fast and simple. Simply slide over the post and you're done. Fits up to 8" post. For corner or end posts. Includes all three end strain elements - insulator, strainer, and steel cable.

Clamp around your standard t-post and tighten. For smooth wire or polywire use only.

Works so much better than the solid shank ones. Like how it holds up the gate.

Protect your valuable horses and livestock from serious injury and unsightly scrapes. Safe-T post caps are designed to conform to a wide range of steel post sizes and stay on tight, eliminating the hazards of sharp, jagged post tops.

Strongest, long-term, end-strain insulation for high tensile permanent electric fencing. 10-year warranty.

Comes packed 12 flags and 12 K-Clips per bag. The stainless steel K-Clips instantly attaches to existing wire fences for geater visibility. These bright white 3" x 5" plastic markers give you a safer, more visible fence, even at night.

Easy to install and stays in place. Cuts installation time in half and eliminates need for terminal insulator. Solution for terminating wire fencing to T-Post and post fencing systems.

Vinyl sleeves slip over T-posts for safety and appearance. Complete with cap.

Reads from 1,000-10,000 volts; lights glow in sequence to indicate approximate voltage. Test voltage under "load" on your fence. For use with all fence energizers. Enables you to test the "control factor" of your system and assist you in fault finding,...

Stretcher consists of two sides that detach and face each other on either side of fence. Chain is attached to stretcher and used in conjunction with come along to pull fence tight to eliminate fence bulge.

Convenient extra long 68" ground cord. The lights are calibrated to illuminate from 625 to 7000 volts. A simple 8-light power indicator for standard or low impedance fencers.

Works like riding on air! The clamp is a pre-formed piece for a 2" round pipe. The 8" tall sturdy metal hub wheel comes with shims for use on gates with less than 1 7/8" O.D. pipe.

Especially good for hi tensile wire. Designed to cut 12½ gauge wire. Pocket-size cutters with hardened jaws.

May be used to terminate the rope at the end of the fence. Features 2 double-post rope clamps and joined by 32” of 12 gauge, shielded wire. Connect and transfer power from 1 strand of 1/4” electric rope or braid to another.