In-Line strainer constructed with a galvanized steel frame and aluminum alloy spool and features a spring loaded clip to keep from unwinding. Recommended for high tensile wire use (usually 12.5 gauge wire).
Hardware not included. Stainless steel contacts. Install at convenient locations like fence corners and gates to switch off a section of fence for maintenance and routine checks.
Activated when fence pulse is detected Switch to change between DVM and Current Meter modes Retractable voltage probe for reading voltage on energizers and other hard to reach areas Micro-chip technology that enables low voltage operation Detachable ground...
The Electric Fence Light is designed to let you know that your electric fence is working properly without any worries. So don't worry if your tester is showing a draw down on your fence while the light is flashing.
Absorbs up to 34 watts of transient power. Plugs into any 110 volt outlet, limits high voltage spikes to 350 volts. Helps protect your 110-volt plug in energizer from power surges caused by lightning strikes.
Convenient extra long 68" ground cord. The lights are calibrated to illuminate from 625 to 7000 volts. A simple 8-light power indicator for standard or low impedance fencers.
Comes complete with two 2-way gate anchors. Electri-Gate is a high conductive stretchable cord with a high impact plastic handle. Has an in-line length adjustor for gates from 8 ft.
For use with all fence energizers. Enables you to test the "control factor" of your system and assist you in fault finding, at a very reasonable price. Test voltage under "load" on your fence.
✓ Recommended for driving T-Posts and using the attached chains at the rear outside of each corner to secure headgate and stand from moving forward as cattle work through the alley
✓ For maximum stability we recommend driving T-posts outside the rear corners of the headgate stand and chain securely
✓ 22.75 In L x 32 In W x 78 In H
✓ Premier panels fit and chain between brackets inside of headgate stand frame
✓ Architectural Grade Powder Coat Finish
✓ Shipping Dimensions: Approximately 78 x 20 x 12 inches. (oversized)
Simply slide over the post and you're done. For corner or end posts. No wire tying, fast and simple. 10-year warranty. Includes all three end strain elements - insulator, strainer, and steel cable.
Made from 1/4” spring steel. Fence compression spring is used to determine wire tension on your fence line. Helps absorb expansion and contraction of the fence wire. One inch of compression equals 150 lbs of tension.
Ideal for use in temporary electric fencing with round posts from 1/4" to 5/8" diameter. Convenient to use when more than one wire is required to hold stock.
