Fence Accessories Livestock Supplies For Sale In Colorado Springs

Has adjustable drag to prevent free wheeling of coil. New improved design has numerous adjustments to keep Hi-Tensile wire coil under control. One-inch shaft turns on greased bushing for smooth operation and long life.

Complete with caps. Vinyl sleeve fits 4" x 4" x 5' posts including gates and corners.

Features a double-post rope clamp connected to a 3/8” terminal with 32” of 12 gauge, shielded wire. Connect a fence energizer to 1/4” electric rope or braid. May also be used to terminate the rope at the end of the strand.

Integrated joint clamp allows direct attachment of wires for paralleling and power connection. The Insulated End Strainer is a heavy duty, all-in-one, corrosion-resistant assembly to insulate, and tighten up to 4 mm/15 gauge fence wire.

Stainless steel contacts. Install at convenient locations like fence corners and gates to switch off a section of fence for maintenance and routine checks. Hardware not included.

Spring is 1 1/2” diameter, expands from 9” to 18”. Made from 1/4” spring steel. Helps absorb expansion and contraction of the fence wire. One inch of compression equals 150 lbs of tension.

Used with Hot Rope or polywire to turn corners or as an end insulator. Bolt measures 6” (measured from the 90 degree angle to the point of bolt.)

For your easy convenience to splice fence.

Lightning blows up the fuse and not your fencer. The only external fuse protection for fence chargers in the world. Just replace your fuse and you're good to go.

Connects power from a 12-volt DC battery to 12-volt energizers equipped with input jack.

Aluminum connector with wire to connect polytape or polywire to your electric fence charger.

Matches the performance meter on Parmak fence chargers but will also read all fence chargers accurately. Easy-to-read digital design, reads up to 19.9 kilovolts. For use with low impedance fence chargers.

Replacement stainless steel K-clips for the Fence Flag (#24135) operation.

Used for adjusting wire tension with the wire strainers.

Complete with cap. Vinyl sleeves slip over T-posts for safety and appearance.

Plugs into any 110 volt outlet, limits high voltage spikes to 350 volts. Helps protect your 110-volt plug in energizer from power surges caused by lightning strikes. Absorbs up to 34 watts of transient power.

Connecting gates to a single post.

Can be installed when putting up fence - or can be retro fitted to existing fence (wood or vinyl post only). For tapes up to 2". 1 per bag with instruction sheet.

10-year warranty. Strongest, long-term, end-strain insulation for high tensile permanent electric fencing.

10 1/4" end to end, 4 3/4" top to bottom, 1/2" rod. Convenient gate latch features black, wrought iron finish.

The Gallagher M1100 Energizer powers up to 110 miles/650 acres of clean fence. While supplies last. Made to last with tough outer casing and built-in lightning diverter with the latest internal circuitry.