Farm Equipment Livestock Waterers For Sale In Tulsa

You can mount this valve on the bottom or on the side and has a bouyancy equal to a 6" round float. Minimum inlet pressure 5 PSI, Maximum inlet pressure 150 PSI. It has an above water float adjustment, cord cleat for shutting off valve and a 1 1/2" water...

O'Ring only replacement for Frost Pro Accessory.

#11 on breakdown. Pride of the Farm Plastic Thumb Screw that connects the Power Link & the Float arm (not included).

Tolerance to water level - you don't have to worry about summer & winter water levels. Sealed bottom keeps out moisture & rodents. Weather strip & an insulated sleeve for the supply line come with each unit.

Robert's Brass 3/4" orfice Valve complete with sand plunger and arms.

SPI 90 degree elbow for all models.

Connects valve to 301 round float. A brass rod float arm 1/4" x 10" with threads on each end.

Good for us in containers up to 50 gallons and sold with many different manufactured automatic livestock waterers. Guaranteed for 1 year & SAFE IN PLASTIC. Thermostatically controlled to only run when necessary.

Pride of the Farm Element for electric waterer units.

Inside repair kit for Topaz & Megaflow Valve.

FEATURES: Side, Bottom, Top Mounting Valve body screws apart by hand for easy servicing Flow stops when unscrewed for servicing Supplied with back-nut and seal washer Built in check valve Fully adjustable Float Angle Pressure range 0-150 PSI Low pressure...

The 101 model takes 1 kit, the 202 & 404 needs 2 kits. Weather seal is for Models 101, 202 & 404 with or without heat.

Suggested where sugar sand is a problem in the water supply. Robert's Brass 3/4" sand plunger only for replacement in existing 3/4" valve.

30 Watt Heater for J303 Corner Mount Horse Stall Waterers.

Robert's 1/2" rubber plunger seat only.

#9 on breakdown. Pride of the Farm 3/4" OD x 1/4" ID DURAPRIDE Plastic Base that screws to your water supply line.

Tolerance to water level - you don't have to worry about summer & winter water levels. Sealed bottom keeps out moisture & rodents. Weather strip & an insulated sleeve for the supply line come with each unit.

These valves are easy to set up and install and their function is so simplistic it is hard for them to fail. After 3 weeks of use, we have no leaks or overflows. If the unit does fail, the animals will still have water as it will flow freely.

Robert's Brass 1/2" orfice Valve complete with sand plunger and arms.

Do Not Immerse into liquid. 450 watt heater, 3" wide x 2 1/4" tall x 11" long, adjustable theromstat multi purpose portable heater.

-Minimal Assembly -Strong Utra-violet Light Protection to prevent Fading/Cracking -One Inch (2.54 cm) Drain Plug (Drain is to the left as you face drinker) -Drinker Opening is: 14.0"(35.6 cm )W 16.5"(41.9 cm) H 12.0"(30.5 cm) D

Robert's 3/4" rubber cup ring that fits on the brass plunger.

It moves the upper to and is also held by a thumbscrew to the float arm. The lower arm is orange and is located in the bottom bracket of the top base and is held by a lock pin.

2" built in drain, stainless steel spring loaded attachment pins make cover removal & replacement easy, recessed, protected notches for secure anchoring, overflow port & dependable non-siphoning Durapride Valve.

600 watt x 120 volt heating element with surface mount thermostat included. Arkfeld waterer element & thermostat replacement.