Farm Equipment Livestock Waterers For Sale In Paterson

15" OD, corrugated plastic tubing insulated inside with Urethane foam to a 10" ID. Used to insulate the Heat Well below the frost line, preventing the loss of energy into the frozen ground.

20 Gallon, 36" x 35" x 25" - 1060# All J Models Heavy duty concrete tank (reinforced with rebar and fibermesh Safe, quick and easy to lift and set Epoxy painted trough and outside Chamfered edges Notched top for controlled overflow Brass or plastic water...

Megaflow Yellow Float Only.

This repair kit fits the Models 101, 202 & 404 with or without heat.

Plastic screw that holds the float arm to the valve's lower arm at the top and the float connect at the bottom.

Connects valve to 301 round float. A brass rod float arm 1/4" x 8" with threads on each end.

Float is easily adjustable for varying water levels, Spring loaded pin allows access panel to pop off with the twist of a screwdriver. Concrete stud lags included, High flow valve.

Engineered with the farmer in mind, this waterer allows easy access to the submersible heater, water line, incoming services and provides effortless cleaning; an extremely low maintenance product.

68 Gallon, 72" x 35" x 25" - 1910# All J Models Heavy duty concrete tank (reinforced with rebar and fibermesh Safe, quick and easy to lift and set Epoxy painted trough and outside Chamfered edges Notched top for controlled overflow Brass or plastic water...

#7 on breakdown. Pride of the Farm 5/32" Orifice on a VP124 Valve. It has O'ring on one side & a Diaphragm on the other (not included).

The one piece construction eliminates cracking & splitting common in plastic-welded, two piece construction tanks. The larger tanks feature incorporated pallet fork openings on the bottom, eliminating accidental punctures while providing easy transportation.

All edges have been rounded for safety & strength. 3 year warranty. The tank also comes with a 1.25" drains installed. The one piece construction eliminates cracking & splitting common in plastic-welded, two piece construction tanks.

Connects valve to 301 round float A brass rod float arm 1/4" x 1 1/2" with threads on each end.

Mostly used on cattle waterers. Blue plastic valve assembly fits a 3/4" FPT with a 3/4" orfice inlet.

The Robert's 3/4" brass valve housing only.

Pride of the Farm Element for electric waterer units.

15" OD, corrugated plastic tubing. Used to extend the Insulated Earth Tube into warm ground below the frost line & form the Heat Well. Won't rust, resists rot & holds up to chemically active soil conditions.

This quick release "D" clip is used on all of the New Generation Energy Free Waterers (4 per Unit) & on the Electric Waterer's inspection plates.

Connects valve to 301 round float. A brass rod float arm 1/4" x 12" with threads on each end.

Typical heating cost for one heating season only $10! 250 Watt, 110 volt heater.

The new Value Series waterers from SPI are a "no tools required" waterer. This 11 gallon waterer can handle up to 100 head of beef with a 250 watts heating element to withstand even those really cold nights.

Mostly used on cattle waterers such as Franklin, SPI & MiraFount and Pride of the Farm. Blue plastic valve assembly fits a 3/4" FPT with a .45" orfice inlet, includes arm that will fit any length, 2 thumbscrews & plastic float.

1000 Watt Immersible element used in the PC2 or PC10 waterer.

That means less pumping and less impoundement of run-off. * Compared to warming tanks with heaters, the Ice Sweeper saves money. * The Ice Sweeper comes with a full 3-year limited replacment warranty, exclusive only of exposed seals.