Farm Equipment Livestock Waterers For Sale In Orlando

SPI 90 degree elbow for all models.

You should use silicon caulk to assure an airtight fit. The heat tube is designed to mate with the cavity under the drinker base. Both the water line & the electrical supply can enter from below.

Pride of the Farm Element for electric waterer units.

Robert's 3/4" rubber plunger seat only.

It is a split plastic coupler that fits into the corrugation of the Earth Tube. Used for joining multiple Earth Tubes.

A drain plug for the Arkfeld waterers - 1 1/2" in size - Black rubber.

The larger tanks feature incorporated pallet fork openings on the bottom, eliminating accidental punctures while providing easy transportation. The one piece construction eliminates cracking & splitting common in plastic-welded, two piece construction...

It measures 3.25" x 4.25" x 2.38". Pride of the Farm White Poly Float that screws into the float arm & turns the water off & on in your waterers.

Megaflow Yellow Float Only.

3/4" orfice only for the inside of a Franklin Valve.

The brass arm and black round ball float only for an Apex Valve.

We are all delighted to have the replacement installed - easy to do - and the waterer functioning perfectly. Our original float valve got broken during the barn remodel.

Unaffected by ground movement due to freezing & thawing. It will take abuse! 15" OD, corrugated plastic tubing insulated inside with Urethane foam to a 10" ID. Used to insulate the Heat Well below the frost line, preventing the loss of energy into the...

Pride of the Farm Element for electric waterer units.

It is held by a float screw and connects on to the bottom of the float arm. Plastic piece that sits on top of the float.

Robert's 3/4" rubber cup ring that fits on the brass plunger.

The larger tanks feature incorporated pallet fork openings on the bottom, eliminating accidental punctures while providing easy transportation. The one piece construction eliminates cracking & splitting common in plastic-welded, two piece construction...

Heating element ONLY for all Johnson Concrete Models EXCEPT the J360.

It has simple installation, attractive design & has animal friendly flaps - no ball or float closures to ice. Weather strip & an insulated sleeve for the supply line come with each unit.

Mostly used on cattle waterers. Blue plastic valve assembly fits a 3/4" FPT with a 3/4" orfice inlet.

#8 on breakdown. Pride of the Farm 5/8" O'ring that goes between the valve base & orifice on a VP124 Valve assembly.

-Minimal Assembly -Strong Utra-violet Light Protection to prevent Fading/Cracking -One Inch (2.54 cm) Drain Plug (Drain is to the left as you face drinker) -Drinker Opening is: 14.0"(35.6 cm )W 16.5"(41.9 cm) H 12.0"(30.5 cm) D

White styrofoam triangular disc float only.

Connects valve to 301 round float. A brass rod float arm 1/4" x 6" with threads on each end.

Robert's Brass 1/2" plunger only for replacement in existing 1/2" valve.

It moves the upper arm and is also held by thumbscrew to the float arm. The lower arm is blue and is located in the bottom bracket of the top base and is held by a lock pin.