Farm Equipment Livestock Waterers For Sale In Ontario

Screw that holds the float connect to the top of the float.

Apex replacement float with string included.

Blue Flap for WPM20 Cattle Waterer

The MicroSweeper is plumbed near the float valve, usually in the port where the petcock was installed. The intermittent flow MicroSweeper can be easily plumbed in any type of waterer, no matter how it was originally equipped.

Guaranteed for 1 year & SAFE IN PLASTIC. Easy to install & installs in only minutes. Custom made to use in all Rubbermaid stock tanks with 1500 Watts of power. Thermostatically controlled to only run when necessary.

It moves the upper to and is also held by a thumbscrew to the float arm. The lower arm is orange and is located in the bottom bracket of the top base and is held by a lock pin.

45 Gallon, 48" x 35" x 25" - 1345# All J Models Heavy duty concrete tank (reinforced with rebar and fibermesh Safe, quick and easy to lift and set Epoxy painted trough and outside Chamfered edges Notched top for controlled overflow Brass or plastic water...

Unaffected by ground movement due to freezing & thawing. It will take abuse! Used to extend the Insulated Earth Tube into warm ground below the frost line & form the Heat Well. 15" OD, corrugated plastic tubing.

SPI 4x4 Rubber Drain Plug only.

Connect valve to 301 round float. A brass rod float arm 1/4" x 4" with threads on each end.

This piece is held by two thumbscrews not included in this part. 3" orange arm that fits between the lower arm and the float connect.

Double wall, single piece poly construction--ALL SMOOTH! Foam filled insulation--R value of 7.5 per inch which offers lots of freeze protection. AS VERSATILE AS YOU CAN GET. Our VT100 valve delivers about 2 1/2 gallons (9.5 liters) per minute.

SPI hatch cover for model 4x4 energy free waterer.

Our VT100 valve delivers about 2 1/2 gallons (9.5 liters) per minute. Four recessed anchor notches for secure installation. Simple water level adjustment, easy to clean. Optional heater, 250 watts, 110 volts.

600 watt x 240 volt heating element with surface mount thermostat included. Arkfeld waterer element & thermostat replacement.

Robert's Brass 3/8" orifice Valve complete with plunger and arms. The R400 series is a high-capacity float valve with male NPT inlet and outlet connections. This model features an adjustable short arm for customizing water level.

Thermostat ONLY for all Johnson Concrete Waterer Models.

This Shut off ball valve is to be used on Models 101, 202 & 404 with or without heat.

250W heater, 2" built in drain, overflow port can be used either as an internal drain or it can be used for optional continuous flow operation, rugged notches for secure anchoring & spring loaded pin allows easy removal of access panel.

Notched flanges for easy anchoring. Stainless steel bolts & removable top afford easy access to plumbing. Livestock can drink out of both flaps at the same time, not always so with a ball closure.

Robert's Brass 3/4" orfice Valve complete with sand plunger and arms.

Same desription as the J202 EXCEPT THIS UNIT HAS NO HEAT!

Pride of the Farm Power Link locks to the VP124 valve body with a link pin & then thumbscrews to the float arm. No other parts are included with this Power Link. #1 on breakdown.

Pride of the Farm VP124 plastic valve body only. No lock pins or inner parts included. #3 on breakdown.

Robert's Brass 3/4" plunger only for replacement in existing 3/4" valve.