Farm Equipment Livestock Waterers For Sale In Midland

Minimum inlet pressure 5 PSI, Maximum inlet pressure 150 PSI. It has an above water float adjustment, cord cleat for shutting off valve and a 1 1/2" water level differential from open to close.

Available in Forest Green in stock, other colors available for special order are Ash Grey, Black, Blue, Red & Tan. The one piece construction eliminates cracking & splitting common in plastic-welded, two piece construction tanks.

80 Watt Immersible element used in the PC 1 waterer.

No other parts come with the Cam Link. #2 on breakdown. This is the arm that opens & closes the plunger. Pride of the Farm Cam Link locks to the VP124 valve body on the top side with a link pin.

Thermostatically controlled to only run when necessary. SAFE IN PLASTIC. Unit measures 7" in diameter, 110v, 1000 Watts. Designed to fit into narrow opening in any hog waterer resevoir.

Available in Forest Green in stock, other colors such as Ash Grey, Black, Blue, Red & Tan available by special order. The one piece construction eliminates cracking and splitting common in plastic-welded, two piece construction tanks.

Robert's 1/2" rubber cup ring that fits on the brass plunger.

This orange plunger holds the seat (not included) and is pushed by the upper arm towards or away from the orfice.

Our R-valve of 7.5 per inch holds the heat provided by incoming water. Over 300 square inches of access for easy hook up. Drinker wells are 14" deep allowing most any animal to drink naturally.

It is FDA & HPB approved, food grade, recyclable plastic. SPI energy free models have a set back seal & drain to help couteract the problems associated with door freeze ups. Drinking height is 15" Door Opening is 9 1/2" x 9 1/2" and trough holds 17 gallons...

Blue 10" replacement ball for the Mira Fount M3465 & M3465E cattle waterer.

Available in Forest Green in stock, also available in Ash Grey, Black, Blue, Red & Tan colors for special order. The one piece construction eliminates cracking & splitting common in plastic-welded, two piece construction tanks.

600 watt x 120 volt heating element with surface mount thermostat included. Arkfeld waterer element & thermostat replacement.

There are no loose parts. You can expect an entire winter's heating bill of $25.00 or less - and this from a drinker that can water 250 head of beef using only 250 watts. Spring loaded pin allows access panel to pop off with the twist of a screwdriver.

30 Watt Heater for J303 Corner Mount Horse Stall Waterers.

600 watt x 120 volt heating element only Arkfeld waterer element replacement.

O'Ring only replacement for Frost Pro Accessory.

No inside working parts included. The orange male fitting end of the Franklin Valve.

Connects valve to 301 round float. A brass rod float arm 1/4" x 7" with threads on each end.

#11 on breakdown. Pride of the Farm Plastic Thumb Screw that connects the Power Link & the Float arm (not included).

SPI 4x4 Rubber Drain Plug only.

It moves the plunger to and from the orfice. The upper arm is blue and is located in the top bracket of the top base and is held by a lock pin.

This quick release "D" clip is used on all of the New Generation Energy Free Waterers (4 per Unit) & on the Electric Waterer's inspection plates.

Float Arm for the Mira Fount M3330 waterer.