Farm Equipment Livestock Waterers For Sale In Hawaii

The larger tanks come with 1.25� drains installed. All edges have been rounded for safety & strength. The one piece construction eliminates cracking & splitting common in plastic-welded, two piece construction tanks.

Johnson Waterer Element Clips to hold the heating element.

600 watt x 240 volt heating element only. Arkfeld waterer element replacement.

This piece is held by two thumbscrews not included in this part. 6 1/2" orange arm that fits between the lower arm and the float connect.

No lock pins or inner parts included. Pride of the Farm VP124 plastic valve body only. #3 on breakdown.

It moves the plunger to and from the orfice. The upper arm is orange and is located in the top bracket of the top base and is held by a lock pin.

SPI 90 degree elbow for all models.

This part number is for the arm only & is usually used on the Polar Max waterers. Pride of the Farm Plastic 3 5/8" Float arm is connected to the Power Link by a thumbscrew & then screws directly into the Poly float.

1000 watt x 120 volt heating element only. Arkfeld waterer element replacement.

A drain plug for Arkfeld waterers - 2" in size - Cork.

The ground mount tube ONLY provides some cold weather protection to your barn stall waterer (not included), but you may need to add heat tape to the water supply line. The heat tube is designed to mate with the cavity under the drinker base.

Red octagon plunger that fits inside the Mira Fount cattle waterer RED valve.

The Tru-Test Apex Xtraflo 3/4" valve with brass rod arm attached to the black round float for Anti-Siphon use.

Blue 10" replacement ball for the Mira Fount M3465 & M3465E cattle waterer.

White styrofoam triangular disc float only.

SPI foamed 4x4 energy free waterer door only.

Won't rust, resists rot & holds up to chemically active soil conditions. 15" OD, corrugated plastic tubing. Unaffected by ground movement due to freezing & thawing. Used to extend the Insulated Earth Tube into warm ground below the frost line & form the...

Robert's 1/2" rubber cup ring that fits on the brass plunger.

High Country Plastics water tanks are rotational molded with high quality FDA approved UV protected plastic to ensure uniform thickness & strength for maximum durability & longevity.

This unit fits the Model 101, 202 & 404 with or without heat.

Blue 10 3/4" replacement ball for the Mira Fount 3354S, M3370S, M3390, M3390E cattle waterers & 3360-10 hog waterer.

A Brass short arm to connect the valve and the round float in Arkfeld and SPI waterers.

Hollow black plug used in all Franklin galvanized waterers.

Pride of the Farm Cam Link locks to the VP124 valve body on the top side with a link pin. This is the arm that opens & closes the plunger. No other parts come with the Cam Link. #2 on breakdown.

This diaphragm fits all Jug Model Valves.