This part number is for the arm only & is usually used on the Polar Max waterers. #12-3 on the breakdown. Pride of the Farm Plastic 3 5/8" Float arm is connected to the Power Link by a thumbscrew & then screws directly into the Poly float.
-Minimal Assembly -Strong Utra-violet Light Protection to prevent Fading/Cracking -One Inch (2.54 cm) Drain Plug (Drain is to the left as you face drinker) -Drinker Opening is: 14.0"(35.6 cm )W 16.5"(41.9 cm) H 12.0"(30.5 cm) D
Engineered with the farmer in mind, this waterer allows easy access to the submersible heater, water line, incoming services and provides effortless cleaning; an extremely low maintenance product.
The R400 series is a high-capacity float valve with male NPT inlet and outlet connections. This model features an adjustable short arm for customizing water level. Robert's Brass 3/4" orifice Valve complete with plunger and arms.
Used to extend the Insulated Earth Tube into warm ground below the frost line & form the Heat Well. Won't rust, resists rot & holds up to chemically active soil conditions. 15" OD, corrugated plastic tubing.
They can also be easily stacked for deeper installations. Highly recommended for ALL cold climate installations. It has an excellent insulating property of R15 and amazing structural strength.
Molded with the most effective ultraviolet inhibitor. Drinker wells are 14" deep allowing most any animal to drink naturally. Tough enough for years of outdoor use. You do need proper installation to prevent the supply line underneath the drinker from...
45 Gallon, 48" x 35" x 25" All J Models Heavy duty concrete tank (reinforced with rebar and fibermesh Safe, quick and easy to lift and set Epoxy painted trough and outside Chamfered edges Notched top for controlled overflow Brass or plastic water valves...
