Farm Equipment Livestock Waterers For Sale In El Paso

Specify model 354, 352 or 351 energy free waterer. SPI foamed door only.

Blue 10 3/4" replacement ball for the Mira Fount 3354S, M3370S, M3390, M3390E cattle waterers & 3360-10 hog waterer.

Black rubber seat to fit inside the Mira Fount Blue Plunger in a Mira Fount cattle waterer valve.

3/4" orfice only for the inside of a Franklin Valve.

It has O'ring on one side & a Diaphragm on the other (not included). #7 on breakdown. Pride of the Farm 1/4" Orifice on a VP124 Valve.

Turns on at 36 degrees and turns off at 48 degrees. Often used in Franklin & Arkfeld waterers. Surface mount thermostat used in galvanized waterers.

If the tank gets a small leak due to unforeseen circumstances, such as a bullet hole, it can be braze welded with a common butane torch to fill in the hole. The one piece construction eliminates cracking & splitting common in plastic-welded, two piece...

Maximum 24-hour electrical use is 1.56 kwh. Dimensions: 41" x 20" x 23". Features: *Open bowl design *Draw Tube for natural drinking action *External Drain Plug for easy cleaning *Sledge hammer tough, rotationally molded plastic construction *Inspection...

Molded with the most effective ultraviolet inhibitor. A typical winter heating bill of $10.00 or less! Why? No loose parts to lose. Incoming water carries heat energy. Tough enough for years of outdoor use.

Weather seal Kit for Jug 101, 202 & 404 with or without heat. 1 per model EXCEPT 404 models need 2 kits.

14, 15, 16 in parts list. B79P Plastic Float with Arm for WFD85 and MFD85 field drinkers. B79P includes:Ref.

Pride of the Farm Plastic Plunger that fits directly into the VP124 valve body & the rubber diaphragm. #5 on breakdown.

Double wall DURAROCK construction contains hindered amine light stabilizer, the most effective ultraviolet inhibitor. Nature's ground water temperature does this job. It has simple installation, attractive design & has animal friendly flaps - no ball...

The lower arm is blue and is located in the bottom bracket of the top base and is held by a lock pin. It moves the upper arm and is also held by thumbscrew to the float arm.

3" orange arm that fits between the lower arm and the float connect. This piece is held by two thumbscrews not included in this part.

They mount above or below the water and give flows of up to 6 gallons per minute. FEATURES: Side, Bottom, Top Mounting Valve body screws apart by hand for easy servicing Flow stops when unscrewed for servicing Supplied with back-nut and seal washer Built...

This part number is for the arm only & is usually used on hog troughs. #12-2 on the breakdown. Pride of the Farm Plastic 2 1/2" Float arm is connected to the Power Link by a thumbscrew & then screws directly into the Poly float.

The upper arm is orange and is located in the top bracket of the top base and is held by a lock pin. It moves the plunger to and from the orfice.

If the tank gets a small leak due to unforeseen circumstances, such as a bullet hole, it can be braze welded with a common butane torch to fill in the hole. The one piece construction eliminates cracking & splitting common in plastic-welded, two piece...

This black seat fits inside the plunger and shuts off the water through the orfice. Must be used with part #400267 Plunger Only.

This piece holds the plunger and upper arm. No inside working parts included. The inside base of the Franklin Valve.

Inside repair kit for Topaz & Megaflow Valve.

AS VERSATILE AS YOU CAN GET. Large 2 External AND Internal (5.1 cm) clean out drains. Our VT100 valve delivers about 2 1/2 gallons (9.5 liters) per minute. The cavity can be used to make the connection from the supply line to our valve.

Arkfeld waterer element replacement. 1000 watt x 240 volt heating element only.

30 Watt Heater for J303 Corner Mount Horse Stall Waterers.

Robert's shut off only arm attached to the bottom of the Robert's Brass Valve.

It will take abuse! 15" OD, corrugated plastic tubing insulated inside with Urethane foam to a 10" ID. Used to insulate the Heat Well below the frost line, preventing the loss of energy into the frozen ground.