Farm Equipment Livestock Waterers For Sale In Columbus

It moves the upper to and is also held by a thumbscrew to the float arm. The lower arm is orange and is located in the bottom bracket of the top base and is held by a lock pin.

This piece is held by two thumbscrews not included in this part. 3" orange arm that fits between the lower arm and the float connect.

SPI foamed door only. Specify model 354, 352 or 351 energy free waterer.

Connects valve to 301 round float. A brass rod float arm 1/4" x 8" with threads on each end.

The 101 model takes 1 kit, the 202 & 404 needs 2 kits. Weather seal is for Models 101, 202 & 404 with or without heat.

The Topaz is compact, robust and manufactured from non-corroding materials. Its diaphragm principle of operation allows the Topaz to give flows of up to 90 gallons per minute. Features Has Detach for quick access to valve seal Mounts horizontally or vertically...

Pride of the Farm Plastic 2 1/2" Float arm is connected to the Power Link by a thumbscrew & then screws directly into the Poly float. This part number is for the arm only & is usually used on hog troughs.

Robert's Brass thumbscrew that connects the short arm and long arm.

Only water that is close to freezing is discharged. No More Frozen Livestock Waterers with the Ice Sweeper Benefits: * Livestock will have access to water because surface ice will not build up in a waterer with a properly installed Ice Sweeper * The thermally...

ICE-N-EASY 1500W, thermostatically controlled to operate only when necessary. Farm Innovators floating tank de-icer has a heavy duty anti-chew cord protector with a 1 year guarantee.

VP2 Valve Upgrade Kit for 1/8" Orifice Valve

These are not included when ordering a base only. There are four base screws that hold the top base to the bottom base.

Robert's shut off only arm attached to the bottom of the Robert's Brass Valve.

This unit fits the Model 101, 202 & 404 with or without heat.

600 watt x 120 volt heating element with surface mount thermostat included. Arkfeld waterer element & thermostat replacement.

15" OD, corrugated plastic tubing insulated inside with Urethane foam to a 10" ID. Unaffected by ground movement due to freezing & thawing. Corrugated design provides rigidity without bulk when back filled with earth.

Foam filled-R value of 7.5 per inch. THE RACE IS OVER. OUR PERFORMANCE ONE BOX STALL DRINKER WINS BY SEVERAL LENGTHS - For corner installations in box stalls--but can be installed outdoors as well.

Thermostat ONLY for all Johnson Concrete Waterer Models.

Robert's Brass 3/4" orfice Valve complete with sand plunger and arms.

This orange plunger holds the seat (not included) and is pushed by the upper arm towards or away from the orfice.

Drinker is very easy to clean--no disassembly for cleaning required. The cavity can be used to make the connection from the supply line to our valve. Large 2 External AND Internal (5.1 cm) clean out drains.

Five controlled temperatures (one just right for you) & no installation required. Saves money by using power only when temperatures require. Turns on at 35 degrees & turns off at 45 degrees.

A drain plug for Arkfeld waterers - 2" in size - Cork.

Mostly used on cattle waterers such as Franklin, SPI & MiraFount and Pride of the Farm. Blue plastic valve assembly fits a 3/4" FPT with a .45" orfice inlet.

#5 on breakdown. Pride of the Farm Plastic Plunger that fits directly into the VP124 valve body & the rubber diaphragm.