Farm Equipment Livestock Waterers For Sale In Colorado Springs

1000 watt x 240 volt heating element only. Arkfeld waterer element replacement.

SPI 90 degree elbow for all models.

This white pin holds the upper arm to the top base.

You should use silicon caulk to assure an airtight fit. Both the water line & the electrical supply can enter from below. The ground mount tube ONLY provides some cold weather protection to your barn stall waterer (not included), but you may need to add...

This two hole, 5.2 gallon waterers uses a 250 or 500 watt submersible heater and can easily ship UPS. No more rust or corrosion! These electric waterers are built of a polyethylene construction creating a strong corrosion free product to provide many...

Mostly used on cattle waterers such as Franklin, SPI & MiraFount and Pride of the Farm. Blue plastic valve assembly fits a 3/4" FPT with a .45" orfice inlet.

This piece is held by two thumbscrews not included in this part. 6 1/2" orange arm that fits between the lower arm and the float connect.

SPI 351/352 New Generation Gasket.

This Shut off ball valve is to be used on Models 101, 202 & 404 with or without heat.

Connects valve to 301 round float. A brass rod float arm 1/4" x 2" with threads on each end.

Robert's 3/4" rubber plunger seat only.

Inside repair kit for Topaz & Megaflow Valve.

They don�t have to learn to lift flaps or push balls and floats are out of the way; they just use their natural sucking method to drink from the open hole. This means clean water without continual maintenance.

Robert's 1/2" rubber plunger seat only.

It measures 3.25" x 4.25" x 2.38". Pride of the Farm White Poly Float that screws into the float arm & turns the water off & on in your waterers.

SAFE IN PLASTIC TANKS. 1 year warranty. Farm Innovator's Submergible 1500 Watt Tank De-Icer operates automatically only during freezing temperatures. It features a heavy duty anti-chew cord protector & operates efficiently at the bottom of the tank; unnoticed...

Blue Flap for WPM20 Cattle Waterer

The cavity can be used to make the connection from the supply line to our valve. Our VT100 valve delivers about 2 1/2 gallons (9.5 liters) per minute. Four recessed anchor notches for secure installation.

-Minimal Assembly -Strong Utra-violet Light Protection to prevent Fading/Cracking -One Inch (2.54 cm) Drain Plug (Drain is to the left as you face drinker) -Drinker Opening is: 14.0"(35.6 cm )W 16.5"(41.9 cm) H 12.0"(30.5 cm) D

#1 on breakdown. No other parts are included with this Power Link. Pride of the Farm Power Link locks to the VP124 valve body with a link pin & then thumbscrews to the float arm.

Won't rust, resists rot & holds up to chemically active soil conditions. It will take abuse! Used to extend the Insulated Earth Tube into warm ground below the frost line & form the Heat Well.

Thermostatically controlled to only run when necessary. Guaranteed for 1 year & SAFE IN PLASTIC. Constructed of Cast Aluminum for ultimate effiency & safety. Good for us in containers up to 50 gallons and sold with many different manufactured automatic...

VP2 Valve Upgrade Kit for 1/4" Orfice Valve

It is manually operated and when turned on allows a continuous flow of water through the valve to assist in the prevention of water freezing in the valve and pipe work supplying it.

3/4" orfice only for the inside of a Franklin Valve.