Farm Equipment Livestock Waterers For Sale In Chattanooga

Plastic piece that sits on top of the float. It is held by a float screw and connects on to the bottom of the float arm.

High Country Plastics Aqua Tank products are rotational molded with high quality FDA approved UV protected plastic to ensure uniform thickness & strength for maximum durability & longevity.

This unit has the same description as the J303 EXCEPT THIS UNIT HAS NO HEAT!

40 Watt x 36" Heat Tape used in the Energy Efficient & All Purpose waterers.

If the tank gets a small leak due to unforeseen circumstances, such as a bullet hole, it can be braze welded with a common butane torch to fill the hole. Available in Forest Green in stock, also available in Ash Grey, Black, Blue, Red & Tan colors for...

6 1/2" orange arm that fits between the lower arm and the float connect. This piece is held by two thumbscrews not included in this part.

Stock Tank With Built-In Drinker Model PRE224BID comes standard with one built-in drinker. -Minimal Assembly -Strong Utra-violet Light Protection to prevent Fading/Cracking -One Inch (2.54 cm) Drain Plug (Drain is to the left as you face drinker) -Drinker...

Robert's Brass thumbscrew that connects the short arm and long arm.

It has O'ring on one side & a Diaphragm on the other (not included). #7 on breakdown. Pride of the Farm 1/4" Orifice on a VP124 Valve.

Seamless sidewall cannot leak. Livestock can drink out of both flaps at the same time, not always so with a ball closure. Notched flanges for easy anchoring. Tolerance to water level - you don't have to worry about summer & winter water levels.

SPI Drain Plug (#11) for all New Generation waterers.

Our 8 notches do not protrude where they can be hit. Water supply line enters through our unique tower. There also is a 3 inch opening at the bottom of the tower which permits drainage through a tile line to a lagoon, Constant flow at 70 gallon and at...

5 year warranty. An Earth Tube is suggested with installation. The D-Clip features no tools required to remove lid, no crossed/stripped thread failures, quick replacement if damaged & commonly available at farm supply stores.

Pride of the Farm Rubber Diaphragm that fits between the orifice & the plunger on a VP124 valve. #6 on breakdown.

Dependable, non-siphoning Durapride valve. It takes a quarter turn with a straight edge screwdriver. (30 years of use) 2" built in drain, overflow port can be used either as an internal drain or it can be used for optional continuous flow operation, rugged...

Robert's 3/4" rubber cup ring that fits on the brass plunger.

A brass rod float arm 1/4" x 1" with threads on each end. Connects valve to round float.

Pride of the Farm White Poly Float that screws into the float arm & turns the water off & on in your waterers. It measures 3.25" x 4.25" x 2.38".

Both the water line & the electrical supply can enter from below. You should use silicon caulk to assure an airtight fit. The ground mount tube ONLY provides some cold weather protection to your barn stall waterer (not included), but you may need to add...

This two hole, 5.2 gallon waterers uses a 250 or 500 watt submersible heater and can easily ship UPS. It has double walled foam-filled molded polyethylene construction. The brass valve and submersible heater are both enclosed by the valve hatch.

Replacement Plastic Valve & Float f/ WFD85 and MFD85 field drinkers.

Seamless sidewall cannot leak. Livestock can drink out of both flaps at the same time, not always so with a ball closure. Notched flanges for easy anchoring. Tolerance to water level - you don't have to worry about summer & winter water levels.

Arkfeld waterer element replacement. 1000 watt x 240 volt heating element only.

If the tank gets a small leak due to unforeseen circumstances, such as a bullet hole, it can be braze welded with a common butane torch to fill the hole. Available in Forest Green in stock, other colors available for special order are Ash Grey, Black,...

450 watt heater, 3" wide x 2 1/4" tall x 11" long, adjustable theromstat multi purpose portable heater. Do Not Immerse into liquid.