Farm Equipment Livestock Waterers For Sale In Austin

It's design reduces stock damage and minimizes blockage. The Tru-Test Apex Xtraflo 3/4" or 1" Trough Valve is a full flow - diaphragm activated, armless, self-cleaning valve mechanism.

SPI 351 (old style) gasket only.

The orange cap only that fits over the insides of the Franklin Valve.

Orange plastic valve assembly fits a 3/4" FPT with a 3/4" orfice inlet. Mostly used on cattle waterers such as Franklin, SPI & MiraFount.

Filter replacement for Topaz & Megaflow Valves.

SPI foamed 4x4 energy free waterer door only.

Blue Flap for WPM20 Cattle Waterer

Used for joining multiple Earth Tubes. It is a split plastic coupler that fits into the corrugation of the Earth Tube.

1000 Watt Immersible element used in the PC2 or PC10 waterer.

Plastic piece that sits on top of the float. It is held by a float screw and connects on to the bottom of the float arm.

Black rubber seat to fit inside the Mira Fount Blue Plunger in a Mira Fount cattle waterer valve.

Constructed of Cast Aluminum for ultimate effiency & safety. This donut shaped 500 Watt De-Icer is designed for multiple uses around the farm. Thermostatically controlled to only run when necessary.

A drain plug for the Arkfeld waterers - 2" in size - Black rubber.

40 Watt x 36" Heat Tape used in the Energy Efficient & All Purpose waterers.

3" orange arm that fits between the lower arm and the float connect. This piece is held by two thumbscrews not included in this part.

A brass rod float arm 1/4" x 12" with threads on each end. Connects valve to 301 round float.

450 watt heater, 3" wide x 2 1/4" tall x 11" long, adjustable theromstat multi purpose portable heater. Do Not Immerse into liquid.

No heat well needed; use an 8-12" tile; can be fitted on most existing pads. Foam insulation between walls has an R-value of 7.14". No pulleys & cable to foul & rust. Dependable, non siphoning valve - proven & trouble free.

Heater included: 250 watts, 110 volts. The bottom has a cavity for warm climate installations only. The cavity can be used to make the connection from the supply line to our valve.

A brass rod float arm 1/4" x 1 1/2" with threads on each end. Connects valve to 301 round float

Weather seal Kit for Jug 101, 202 & 404 with or without heat. 1 per model EXCEPT 404 models need 2 kits.

Arkfeld waterer element replacement. 600 watt x 240 volt heating element only.

Valve 36" Float Cord Only.

If the unit does fail, the animals will still have water as it will flow freely. These valves are easy to set up and install and their function is so simplistic it is hard for them to fail.

This diaphragm fits all Jug Model Valves.

Heating element ONLY for the Johnson Concrete Model J360.