Farm Equipment Livestock Waterers For Sale In Augusta Richmond County

600 watt x 120 volt heating element only Arkfeld waterer element replacement.

The Pride of the Farm "King" Energy Efficient drinker is beefy & ruggedly built but simple. You can expect an entire winter's heating bill of $25.00 or less - and this from a drinker that can water 250 head of beef using only 250 watts.

Robert's 3/4" rubber plunger seat only.

Constructed of Cast Aluminum for ultimate effiency & safety. Guaranteed for 1 year & SAFE IN PLASTIC. Thermostatically controlled to only run when necessary. This donut shaped 500 Watt De-Icer is designed for multiple uses around the farm.

This Complete Valve is used on the J303 or J303EF Corner Mount Horse Stall Waterer.

Pride of the Farm Element for electric waterer units.

This piece is held by two thumbscrews not included in this part. 6 1/2" orange arm that fits between the lower arm and the float connect.

This repair kit fits the Models 101, 202 & 404 with or without heat.

High Country Plastics water tanks are rotational molded with high quality FDA approved UV protected plastic to ensure uniform thickness & strength for maximum durability & longevity.

Do Not Immerse into liquid. 450 watt heater, 3" wide x 2 1/4" tall x 11" long, adjustable theromstat multi purpose portable heater.

High Country Plastics water tanks are rotational molded with high quality FDA approved UV protected plastic to ensure uniform thickness & strength for maximum durability & longevity.

-Minimal Assembly -Strong Utra-violet Light Protection to prevent Fading/Cracking -One Inch (2.54 cm) Drain Plug (Drain is to the left as you face drinker) -Drinker Opening is: 14.0"(35.6 cm )W 16.5"(41.9 cm) H 12.0"(30.5 cm) D

SPI 3.75" Brass Short Float Stem only.

It's maximum 24-hr electical use is 1.56 kwh. Features: *Open bowl design *Draw Tube for natural drinking action *External Drain Plug for easy cleaning *Sledge hammer tough, rotationally molded plastic construction *Inspection cover for easy access to...

Mostly used on Franklin hog waterers. Orange plastic valve assembly fits a 3/4" FPT with a 1/2" orfice inlet.

It's design reduces stock damage and minimizes blockage. Minimum inlet pressure 5 PSI, Maximum inlet pressure 150 PSI. It has an above water float adjustment, cord cleat for shutting off valve and a 1 1/2" water level differential from open to close.

Use this valve assembly with the J303 with without heat.

Robert's Brass 1/2" plunger only for replacement in existing 1/2" valve.

Corrugated design provides rigidity without bulk when back filled with earth. Won't rust, resists rot & holds up to chemically active soil conditions. It will take abuse! Used to extend the Insulated Earth Tube into warm ground below the frost line &...

A drain plug for the Arkfeld waterers - 1 1/2" in size - Black rubber.

Unlike the original concept of the submerged bulb to sense water temperature, this unit senses the air temperature immediately surrounding the water basin, therefore, it is not designed for water submersion.

You don't need extra heat to keep the line above the ground open. The more water, the more heat. Stainless steel spring loaded valve cover removes easily. Two large drink openings 8" x 14" each.

Same desription as the J202 EXCEPT THIS UNIT HAS NO HEAT!

Pride of the Farm Element for electric waterer units.