Auto Maintenance Parts Engine Ignition For Sale In New Jersey

• ✓ Made from high quality material
• ✓ 2 in. outside diameter
• ✓ Grooved
• ✓ Shipping Dimensions: Approximately 11.3 x 1.92 x 1.92 inches.
• ✓ Part Number - 27280

• ✓ Weight: Approximately: .05 pounds
• ✓ (2.0mm2) .250 in. tab (6.4mm)
• ✓ Shipping Dimensions: Approximately 4 x 2 x .68 inches.

• ✓ Shipping Dimensions: Approximately 9.25 x 7.25 x 6.63 inches.
• ✓ This product cannot be shipped to: CA
• ✓ Starters tested to meet or exceed O.E. standards for insulation quality, phase balance, and amp output, or replaced with new
• ✓ All external mounting holes re-threaded
• ✓ New insulators & hardware
• ✓ New regulators and diode trios on delco SI type

• ✓ Shipping Dimensions: Approximately 4 x 2 x 1.63 inches.
• ✓ Stud type low voltage circuit breakers with mounting bracket
• ✓ Weight: Approximately: .4 pounds
• ✓ Used primarily as a wiring harness protector in 12 volt DC automotive systems

• ✓ Part Number - 27271
• ✓ Shipping Dimensions: Approximately 6.5 x 5.25 x .44 inches.
• ✓ This product cannot be shipped to: CA
• ✓ Resistant to high temperatures

• ✓ Provides a precise response to your vehicle's cooling system needs
• ✓ 190 degrees
• ✓ Weight: Approximately: .2 pounds
• ✓ This product cannot be shipped to: CA
• ✓ The heat motor is 100 percent calibrated to ensure quality and performance

• ✓ Includes 72 in. high temperature nylon tubing with 1/8 in. & 1/4 in. NPT thread fittings
• ✓ Weight: Approximately: 1.25 pounds
• ✓ Includes gauge & mounting hardware
• ✓ Includes 12 Volt internal backlighting
• ✓ Features black bezel with removable black mounting panel
• ✓ Standard 1-1/2 in. black dials

• ✓ With jiggle pin
• ✓ 195 degrees SuperStat
• ✓ Offers more efficient temperature control resulting in faster warm-ups, better fuel economy, & longer engine life
• ✓ This product cannot be shipped to: CA
• ✓ 1-13/16 in. x 3/4 in. x 61/64 in.
• ✓ Premium thermostat

• ✓ This product cannot be shipped to: CA
• ✓ Weight: Approximately: .34 pounds
• ✓ Button terminals
• ✓ Shipping Dimensions: Approximately 4.8 x 2.8 x 2.25 inches.

• ✓ All fans & pulleys plated or dipped to inhibit rust & corrosion
• ✓ New brushes, brush springs and bearings
• ✓ New insulators & hardware
• ✓ Shipping Dimensions: Approximately 9.25 x 7.25 x 6.63 inches.
• ✓ Rotors electronically tested for amperage & insulation quality
• ✓ This product cannot be shipped to: CA

• ✓ Weight: Approximately: 8.05 pounds
• ✓ This product cannot be shipped to: CA
• ✓ All solenoides remanufactured to meet or exceed OEM standards
• ✓ Brush leads welded, not soldered
• ✓ Additional exchange fees may apply
• ✓ All starter drives remanufactured to meet or exceed OEM standards

• ✓ Makes connecting & disconnecting wires quick & easy
• ✓ 2.0mm2
• ✓ Blue
• ✓ Shipping Dimensions: Approximately 4 x 2 x .68 inches.

• ✓ On-Off SPST
• ✓ 1/2 in. round mounting hole
• ✓ Rocker switches are an economical & space-saving alternative to multiple switches
• ✓ Shipping Dimensions: Approximately 5 x 3 x 1.25 inches.

• ✓ 399 pieces of neatly contained organized within a durable, lightweight, reusable carry-case with handle
• ✓ Offers a convenient solution for almost any vehicle's electrical applications & is packed with items necessary to complete most emergency electrical repairs
• ✓ This product cannot be shipped to: CA
• ✓ Tester is designed with a sharp probe tip to pierce insulation includes alligator test lead & provides visual indication of power to help pinpoint any electrical failure
• ✓ Packed with the most popular sizes of fuses, terminals, wire nuts, cable ties & wire clips
• ✓ Weight: Approximately: 4.5 pounds

• ✓ Made in the USA
• ✓ Contains starter drive, drive end bushing, needle bearing set, brush set & thrust washers
• ✓ Contains snap ring & snap ring retainer
• ✓ Weight: Approximately: .8 pounds
• ✓ For 1988-2000 GM SD210 & SD260 direct drive starters
• ✓ Quality parts, OEM specifications or better

• ✓ Weight: Approximately: .6 pounds
• ✓ Shipping Dimensions: Approximately 9.75 x 7 x .75 inches.
• ✓ Includes easy-to-follow illustrated instructions in English, Spanish & French
• ✓ Made in the USA
• ✓ Contains rectifier, bearings drive end and commutator end & bearing retainer
• ✓ For 1993-2004 GM 100-140 amp CS 130D series alternators

• ✓ Not only are Briggs & Stratton genuine parts guaranteed to fit, but using them ensures that the Briggs & Stratton engine they are installed on complies with applicable (EPA) emission regulations
• ✓ There are no substitutes when it comes to keeping engine powered equipment healthy to maximize engine life, meet original equipment specs and provide full warranty coverage, always use genuine parts from Briggs & Stratton

• Manufacturer Warranty: One year limited warranty
• Product Height (in.): 5
• Product Width (in.): 0.25
• Product Depth (in.): 4

• ✓ Extend the life of your equipment by doing routine maintenance
• ✓ Includes: fuel filter, fuel lines, grommet, fuel cap, gasket, fuel tank vent and purge bulb
• ✓ Product is regulated for use with off-road engines and equipment under EPA 40 CFR Part 1060 and must be used on engines/equipment built after 1/1/2012
• ✓ For use on: ECHO trimmers, brushcutters, edgers, and power attachment series (PAS)
• ✓ Fits models: GT-225/i/L/SF, SRM-225/i/SB/U, PE-225, PAS-225/SB

• Fits Brands: ECHO

• ✓ Weight: Approximately: .13 pounds
• ✓ Unit with bottom Q.C. terminals includes detachable side mounting brackets
• ✓ Shipping Dimensions: Approximately 4 x 4 x 1.25 inches.
• ✓ This product cannot be shipped to: CA

• ✓ Help keep your outdoor power equipment running at peak performance by using Briggs & Stratton replacement and maintenance parts
• ✓ Only Briggs & Stratton genuine parts are specially designed to exact OEM standards, manufactured and tested to help deliver optimum performance in Briggs & Stratton engines

1

• Product Width (in.): 1
• Manufacturer Warranty: 1 Year Limited
• Product Depth (in.): 20.25
• Product Height (in.): 1

• ✓ Fits Redmax Trimmer Chainsaws Brush Cutter T207071200
• ✓ Ships from the USA!

• Brand: SPU

• ✓ Simply crimp both ends for a long-lasting, secure connection
• ✓ Weight: Approximately: .09 pounds
• ✓ Provides a quick & reliable crimp-type connection & wire repairs
• ✓ Shipping Dimensions: Approximately 4 x 2 x .68 inches.

• ✓ Install and remove without tools
• ✓ Compatible with Gemini Jr. convertible hand trucks with die case noses only
• ✓ Aluminum deck is lightweight and impact resistant

• Manufacturer Warranty: One year warranty from date of purchase against defects in workmanship or material.
• Fits Models: All Magliner brand hand trucks
• Product Width (in.): 12

• ✓ Only Briggs & Stratton genuine parts are specially designed to exact OEM standards, manufactured and tested to help deliver optimum performance in Briggs & Stratton engines
• ✓ Used on models 122T02,122T05,122T07,124L02,126L02,126L05,126L07,126M02,126M05,126M07,128M02,128M05,128M07.

• Part Type: Engine Part
• Returnable: 90-Day
• Product Width (in.): 2.75
• Engine Part Type: Thermostat

• ✓ Dura-bore cast iron cylinder sleeve for extended life
• ✓ Large rewind starter reduces pulling effort for easy starting
• ✓ Mechanical torque control for additional power
• ✓ Crankshaft: 25 mm Dia x 3-5/32 in. L, 2 WK and keyway

• Engine Part Type: Engine
• Returnable: 90-Day

• ✓ Includes gear and clutch reduction and recoil start
• ✓ 0.75 in. keyway output shaft

• Engine Type: 4 Cycle
• Product Depth (in.): 17
• Manufacturer Warranty: 3 Year Warranty
• Fuel Tank Capacity (gallons): 1.0

• ✓ Only Briggs & Stratton genuine parts are specially designed to exact OEM standards, manufactured and tested to help deliver optimum performance in Briggs & Stratton engines
• ✓ Used on models 098902,09D902,09J902,09L902,095502,09T502,09T702,10A902,10D902,10T502,10T702

• Product Depth (in.): 3
• Part Type: Engine Part
• Product Height (in.): 0.25
• Engine Part Type: Spring