Applicators Accessories Livestock Supplies For Sale In Henderson

Blue pin is required when using the Allflex Universal Total Tagger to apply Allflex Piglet Tags.

Black clip used in Allflex tagger to apply Allflex Global Tags.

Deep penetrating formula has a 5 year guarantee when applied properly. Comes with 3 tips, 2 broad and 1 fine.

Tagger used to apply Hasco Metal Cattle Tags.

The VetGun comes with a CO2 adaptor that fits a specific CO2 cartridge size: either the 25 gm OR the 90 gm. Gives you the flexibility to switch between CO2 cartridge sizes, if desired.

Extra flip-out pin for use with the ZTag Z2 No-Tear Tagger. Used to apply Z2 2-Piece No-Tear Ear Tags.

Pin used in Y-Tex applicator to apply Y-Tex tags.

Matches the performance meter on Parmak fence chargers but will also read all fence chargers accurately. For use with low impedance fence chargers. Easy-to-read digital design, reads up to 19.9 kilovolts.

Connects power from a 12-volt DC battery to 12-volt energizers equipped with input jack.

Ink actually penetrates surface of tag as it dries, insuring a good bond. Ball-point tip. Permanent marking of ear tags.

Used for adjusting wire tension with the wire strainers.

Shaft tool allows for more flexibility when engraving Ritchey tags. Used with Dremel tool.

Nylon snap-on clip insulators for use with the Insulated Line Post.

For use with these energizers: S10, S16, S22, and B700.

Category I and II hitch pins. 10 ga powder-coated steel frame. Heavy duty 3-point Stump Jumper Design with 5/8" safety bar to protect undercarriage. Category I, II and III Narrow Quick Hitch Compatibility.

Ideal for use in temporary electric fencing with round posts from 1/4" to 5/8" diameter. Convenient to use when more than one wire is required to hold stock.

For use with ground rods for proper electric fence grounding.

Just the right size to suspend vertically in front of mineral feeders or in entry way of creep feeders. Approximately 18" long with a metal ring at the top. Made from the same rot proof materials as the rub.

This bracket functions to terminate or anchor the end of a rail on an end or gate post. Simple design requires no wire stripping or special tools, making termination quick and easy.

The book will walk you through the tools of beekeeping, the steps necessary to build and maintain your own beehives, and the phases of honey production and extraction. It also provides new information on mites and the causes and effects of Colony Collapse...

Clamp around your standard t-post and tighten. For smooth wire or polywire use only.

The one way barrel tensioner is a CenFlex rail accessory. Of straight fence line. This piece functions to tension and terminate the rail at gate or end post. For every major directional change.

Protect your valuable horses and livestock from serious injury and unsightly scrapes. Safe-T post caps are designed to conform to a wide range of steel post sizes and stay on tight, eliminating the hazards of sharp, jagged post tops.

Sprayer includes corrosion resistant polyethylene tank with molded-in gallon markers, 12-volt 3.8 GPM diaphragm pump with 45 PSI maximum, 5" screw-on cap, full length drain sump, 8' wire harness with clips and on/off switch, deluxe pistol grip handgun...

Its function is to connect two pieces of rail creating one longer piece. Simple design requires no wire stripping or tools, making splicing rail quick and easy. The splice buckle is a CenFlex rail accessory.

Plugs into any 110 volt outlet, limits high voltage spikes to 350 volts. Absorbs up to 34 watts of transient power. Helps protect your 110-volt plug in energizer from power surges caused by lightning strikes.