Accessories Electric Fencing For Sale In Jacksonville

10-year warranty. Long-life Super Strain Insulator with pre-attached stainless steel cable. Fits up to 8" post. No wire tying or special tools required.

1 1/2" Tape Clip, designed specifically for equine electric fence tape to be securely attached to a Gallagher Insulated Line Post.

10-year warranty. Strongest, long-term, end-strain insulation for high tensile permanent electric fencing.

May also be used to terminate the rope at the end of the strand. Connect a fence energizer to 1/4” electric rope or braid. Features a double-post rope clamp connected to a 3/8” terminal with 32” of 12 gauge, shielded wire.

Acceptable for all types of electric fence material. 2 alligator clamps joined by 32” of shielded wire. Connects and transfers power from 1 strand to another.

Complete with two connectors and wire to connect two strands of polytape or polywire. Quick and convenient way to make a good electrical connection to your polytape or polywire.

Absorbs up to 34 watts of transient power. Helps protect your 110-volt plug in energizer from power surges caused by lightning strikes. Plugs into any 110 volt outlet, limits high voltage spikes to 350 volts.

Spinning Jenny is adjustable to fit the inside diameter of wire rolls from 17 to 24 inches. Use Zareba Spinning Jenny Fence Wire De-Reeler for easy payout of coiled high tensile wire.

No complaints whatsoever! I purchased these polytape splicers at the beginning of summer to use on our temporary grazing fencing. The fence stays together even when crows choose to rest on the wire, and when it rains and storms and gets windy, etc.

Connects power from a 12-volt DC battery to 12-volt energizers equipped with input jack.

The half spring, springload internal mechanism will not allow you to over stretch. Premium gate handle with comfortable rubber grip and unique internal overstretch protection.

Connecting gates to a single post.

10-year warranty. The Insulated End Strainer is a heavy duty, all-in-one, corrosion-resistant assembly to insulate, and tighten up to 4 mm/15 gauge fence wire. Integrated joint clamp allows direct attachment of wires for paralleling and power connection.

Standard 3/8 In. hole for easy installation. Zareba Electric Fence Galvanized Brace Pin 5 in. They are also used for all brace pos and anchor post assemblies. Is used to attach horizontal brace posts to vertical brace posts in corners.

Easy to use and portable! Install the S10 or S16 Energizer on a Gallagher Ring Top Post (#40990) using this post mount.

Safe-T post caps are designed to conform to a wide range of steel post sizes and stay on tight, eliminating the hazards of sharp, jagged post tops. Protect your valuable horses and livestock from serious injury and unsightly scrapes.

For use with these energizers: S10, S16, S22, and B700.

Fits the 13-19' and 18-24' gate.

Every friction point (corners, bends, dips, rises) reduces the strainer's capacity by about 500 feet. Use Zareba In-Line Strainer to increase tension on high tensile fence wire to about 250 lbs.

Bolt measures 6” (measured from the 90 degree angle to the point of bolt.) Used with Hot Rope or polywire to turn corners or as an end insulator.

Featured video, click image to play.

Cords are 46" long and clamps are 3". Made with heavy-duty alligator clamps and double-shielded, high-voltage wire for leak-proof transfer of power from the energizer to the fence and ground rods.

Replacement stainless steel K-clips for the Fence Flag (#24135) operation.

Electric Fence is ideal for added security on an existing fence or as a low-cost temporary or permanent fencing alternative. OK Brand High-Tensile Field Fence is 12-1/2 gauge, 170,000 PSI and 4,000 ft.