Accessories Electric Fencing For Sale In Arizona

Nylon snap-on clip insulators for use with the Insulated Line Post.

Made with heavy-duty alligator clamps and double-shielded, high-voltage wire for leak-proof transfer of power from the energizer to the fence and ground rods. Cords are 46" long and clamps are 3".

Eagle Picher Electric Fence Battery 4 Volt is for Zarebra electric fence models SP-8904, SP-44, SP-504, SP-904 and SP-4404. It is a sealed lead acid (AGM) termination .187 in.

Replacement spool for winding and unwinding portable fencing.

Claw style insulator ideal for use in temporary electric fencing with rod posts 3/16" - 3/8" diameter. Fits Ring Top Post (#40990).

Gallagher Cut-Off Switch (Knife) is used at gates and for easy location of fault finding. Switch off a section of fence for maintenance and routine checks.

Power Patrol Electric Fence Battery 12 Volt is a 5 amp 12 volt fencer battery. It is a sealed lead acid (AGM) termination .187 in.

Standard 3/8 In. hole for easy installation. Is used to attach horizontal brace posts to vertical brace posts in corners. Zareba Electric Fence Galvanized Brace Pin 5 in. They are also used for all brace pos and anchor post assemblies.

Convenient extra long 68" ground cord. A simple 8-light power indicator for standard or low impedance fencers. The lights are calibrated to illuminate from 625 to 7000 volts.

Strongest, long-term, end-strain insulation for high tensile permanent electric fencing. 10-year warranty.

For use with all fence energizers. Test voltage under "load" on your fence. Enables you to test the "control factor" of your system and assist you in fault finding, at a very reasonable price.

Important tool for monitoring fence line performance. Recommended for regular maintenance of fence line. Easy to operate. Neon lights indicate voltage from 600 to 7,000 volts. No battery required.

Complete ground rod kit to get the most from your electric fence system. Contains 3 six foot galvanized rods, 3 heavy duty clamps, 48' connection wire and complete instructions.

Just replace your fuse and you're good to go. The only external fuse protection for fence chargers in the world. Lightning blows up the fuse and not your fencer.

Activated when fence pulse is detected Switch to change between DVM and Current Meter modes Retractable voltage probe for reading voltage on energizers and other hard to reach areas Micro-chip technology that enables low voltage operation Detachable ground...

Stainless steel clips for use with 3/8" or 1/2" fiberglass posts. Pig tail clips may be used instead of insulators.

1 1/2" Tape Clip, designed specifically for equine electric fence tape to be securely attached to a Gallagher Insulated Line Post.

Displays fence voltage from 10kV to 12kV in 1,000 volt increments. Fence stud - for quick, no fuss contact with fence. Activated when fence pulse is detected Auto turn-on indication.

One-inch shaft turns on greased bushing for smooth operation and long life. New improved design has numerous adjustments to keep Hi-Tensile wire coil under control. Has adjustable drag to prevent free wheeling of coil.

If something touches the fence, the light will not flash and the full charge will go to whatever is touching your fence. It flashes on and off with every pulse of the fencer with very little draw down of the voltage.

May also be used to terminate the rope at the end of the strand. Connect a fence energizer to 1/4” electric rope or braid. Features a double-post rope clamp connected to a 3/8” terminal with 32” of 12 gauge, shielded wire.

May be used to terminate the rope at the end of the fence. Connect and transfer power from 1 strand of 1/4” electric rope or braid to another. Features 2 double-post rope clamps and joined by 32” of 12 gauge, shielded wire.

Use this pair of Zareba Systems battery clips to attach lead-out wire from fence controller to battery.